After the enormous success of our first Wireless Spider and the feedback from our many satisfied customers, we went back to the drawing board for a completely new version. The result: The WispiRAE 2!

Traditional SpidersHave you ever worked with a traditional spider? They are indispensable for many projects. But they are also heavy and unmanageable, take days to install by quali� ed personnel, and require enormous cable reels. There’s no back-up power or it is an expensive option, so when someone unwittingly breaks a cable by driving over it, the system is inoperative and the project is on hold. Redundancy cables solve this problem with even more cables. As if that wasn’t enough, the cables are very expensive, your personnel could trip over it or topple over equipment or even breaking it. To install a system like this requires a truck and a fork lifter to install or move. Sounds familiar? Not anymore! Rapid deploymentThe WispiRAE 2 is delivered turn-key. And when we say turn-key, we mean exactly that. All systems are precon� gured and programmed for your application. All equipment � ts in a small van. Everything is installed simply by placing the sensors and turning them on, putting the WispiRAE 2 in its place, connecting switchable equipment, turn the power on, job done! Installation is complete within a few hours, quite literally within the time it takes to walk around every measuring location. Without trucks on your premises, virtually without cables, without fork lifts, without a huge crew. And safe in all respects: intrinsically safe to Zone 0, resistant to all weather, easy and fool-proof to operate and with no cables.The data network is initiated automatically, the sensor heads use each other to send data to the WispiRAE 2 and other central units. In the unlikely event of sensor failure, the system automatically alarms the central unit, but data and alarms of other sensor heads are not compromised because the network is re-initiated automatically. You don’t miss a beat and we will be there to repair or replace the faulty head.

Applications

• Plant maintenance and turnarounds • Industrial safety• Oil and gas• Oil and chemical storage• Marine

Key Features• Turn-key wireless area monitoring: Place, Power Up,

Ready!• Intrinsically Safe Zone 0• Range at least 300 meters• Available with UMTS, data logging, automatic SMS-

messaging• Faultfree design• Programmable for switching alarms, ventilation, power

current• Fully designed for the toughest environments• Available with a complete range of batteries and so-

lar panel power supplies for uninterupted operation

RAE Benelux Belgium

Amsterdamstraat 28 2321 Hoogstraten

Telephone +32 (0)3 - 3138003 Fax +32 (0)3 - 293 42 46www.rae.be

RAE Benelux BV

Hoofdweg 34C 2908 LC Capelle a/d IJssel

Telephone +31 (0)10 - 442 6149 Fax +31 (0)10 - 442 6148 www.rae.nl

NEWRAE Benelux presents

Wireless Spider 2 The Ultimate in Mobile Gas Detection Protection for Plant Turnarounds and O� shore

RAE Benelux presents

Wireless Spider 2 The Ultimate in Mobile Gas Detection Protection for Plant Turnarounds and O� shore

As rugged as it getsFailing alarm equipment means a project on hold: unacceptable, whether caused by system or human faults. That’s why the WispiRAE 2 system is as rugged as it can be. It consists of a mobile framework to which an explosion-proof housing, MeshGuard sensor heads, a siren and beacon are attached. The housing contains an FMC 2000 multichannel controller and a battery. The controller reads out measuring data of all connected MeshGuards and sends data and alarms through its built-in modem. Its Zone 0 certi� cation means that the MeshGuards can even be used in con� ned spaces. The WispiRAE 2 can be used in Zone 1-environments.The requirements of ultimate ruggedness of a housing like the WispiRAE’s are enormous, hence why the lid is screwed in place with 20 heavy-duty bolts. To prevent having to unscrew all these bolts when making changes to the con� guration or setup, the WispiRAE 2 is � tted with programming buttons on the outside.

Groups of personnel protected in one sweepThe WispiRAE is supremely suited to protect crews in dangerous areas and warn them against poisonous gases and imminent danger of explosion. To cover a broader area, multiple MeshGuards can be placed in key locations, making use of the same network. The WispiRAE 2 monitors any measurements and alarms correspondingly.Through this enormous versatility and � exibility, but also its ruggedness, the WispiRAE 2 will prove itself ideal to assist you and your personnel with plant turnarounds and o� shore working environments. But also when work is planned to a � xed gas detection system, the WispiRAE 2 system is a comprehensive substitute for the protection of your crew.The MeshGuard gas detection monitor is the building block of an intelligent network of interconnected sensor heads for applications of industrial safety. The MeshGuard system is developed to deploy instead of traditional � xed gas detection

Operation and programming from the outside, protected with key

RAE Benelux Belgium

Amsterdamstraat 28 2321 Hoogstraten

Telephone +32 (0)3 - 3138003 Fax +32 (0)3 - 293 42 46www.rae.be

RAE Benelux BV

Hoofdweg 34C 2908 LC Capelle a/d IJssel

Telephone +31 (0)10 - 442 6149 Fax +31 (0)10 - 442 6148 www.rae.nl

NEW

RAE Benelux presents

Wireless Spider 2 The Ultimate in Mobile Gas Detection Protection for Plant Turnarounds and O� shore

MeshGuard with heavy duty ATEX battery pack

monitors. The MeshGuard o� ers a cheaper solution that is deployed instantaneously. The MeshGuards are available with a host of � eld-replaceable precision sensors for poisonous and/or combustible gases. Of course, it’s ATEX certi� ed.

The FMC 2000 is at the heart of the WispiRAE 2; a multichannel controller with built-in modem, developed to integrate RAE System’s wireless networking products like the MeshGuard. It is easy to use, versatile and supremely reliable.The FMC 2000 manages the measurement data of all connected MeshGuards and alarms when necessary. It can control 24 detectors simultaneously. This turns the WispiRAE into the heart of a simple to use and install but versatile and safe network of gas surveillance. Furthermore, the FMC 2000 is equipped with data logging, so information about alarm situations can be analyzed and stored to ease reporting. The FMC 2000 is equipped with a backup battery, so even when power is interrupted or switched of, none of the incoming data is lost. It can only be used in ATEX-zones by building it into the WispiRAE 2.The housing has an IP65 rating so it can be used in the toughest of circumstances. This build quality ensures optimal protection of the sensitive equipment inside, even when it is not ATEX-certi� ed.Also, you bene� t from the latest in communication technology. We built in UMTS- and SMS-connectivity so supervisors can be alarmed automatically in case of emergencies and critical data is always available.

Custom built for your projectMake an appointment with RAE Benelux to see for yourself how your project can be carried out cheaper, safer, faster and surer. The WispiRAE 2 and all related equipment is for rent at RAE Benelux.

Components

A high current junction box, switched by WispiRAE 2

RAE Benelux Belgium

Amsterdamstraat 28 2321 Hoogstraten

Telephone +32 (0)3 - 3138003 Fax +32 (0)3 - 293 42 46www.rae.be

RAE Benelux BV

Hoofdweg 34C 2908 LC Capelle a/d IJssel

Telephone +31 (0)10 - 442 6149 Fax +31 (0)10 - 442 6148 www.rae.nl

NEW

RAE Benelux presenteert

Wireless Spider 2 The Ultimate in Mobile Gas Detection Protection for Plant Turnarounds and O� shore

FMC 2000 controller

Dimensions 24 x 40 x 9.3 cm LxBxH

Weight 6.5 kg

Visible alarms Superbright LEDs (aided by WispiRAE 2 alarms)

Audible alarms 95dB @ 30cm (aided by WispiRAE 2 alarms)

RF frequency 2.4 GHz ISM band, conforms to IEEE 802.15.4 standard

Detectors Controls up to 24 detectors remotely

Keys and display 16 metal programming keys, operated from the outside of WispiRAE 25.7” gra� c LCD320x240 pixels with background lighting

Power supply 85 - 264V ACRechargeable battery, 6V, 4 Ah, for up to 14 hours of autonomous use

Relay 4 SPDT relays (6A 250 V AC)

Operating temp. -20° to +55° C

Humidity 0 - 90% RH, non-condensing

Datalogging SD memory card (1GB)

Certi� cate FCC: QNT-PT2400S20-ACE EN 300320 (RTTE directive)

Housing and peripheralsATEX Housing

Certi� cate Ex II 2GD Ex d IIC [...] T3 .. T6 Zone 1, 2, 21 & 22

IP-rating IP65

Operating temp. -20° to +40° C

Material Copper-free aluminum

HornSound pressure 100 dB(A)

Certi� cate Ex II 2GD Ex d IIC T6 Zone 1, 2, 21 and 22

IP-rating IP65

Operating temp. -20° to +55° C

Material Copper-free aluminum

StrobeCerti� cate Ex II 2GD Ex d IIC T6 Zone 1, 2, 21 and 22

IP-rating IP65

Operating temp. -20° to +40° C

Material Copper-free aluminum

All speci� cations subject to change and improvement without prior notice.

Specifications

MeshGuard sensor heads

Sensor speci� cations*

Gas Range Resolution Response time

Carbon Dioxide (CO) 1 - 500 ppm 1 ppm 30 sec

Hydrogen Sul� de (H2S) 0.1 - 100 ppm 0.1 ppm 20 sec

Sulfur Dioxide (SO2) 0.1 - 20 ppm 0.1 ppm 30 sec

Combustible Gases (LEL) 0 - 100% LEL 1% LEL 15 sec

*Other sensors possible, please contact RAE Benelux

Instrument speci� cations

Dimensions 26.5 cm x 9.5 cm x 5.5 cm LxBxH

Weight 0.6 kg

Visible alarms 2 Superbright LEDs

Audible alarms 90dB @ 30cm

RF broadcasting freq. 2.4 GHz ISM band, conforms to IEEE 802.15.4 standard

Operating range 300 meters (in line of sight)

Keys and display Three operation and programming keysLCD 72x108mm with background lighting

Power supply Lithium battery for single use, +3,6VOptional rechargeable external long lasting battery

Operating time Sensors for toxic gases: Up to 6 months with internal battery (2 years with PowerPak)Sensors for combustible gases:Up to 5 days with internal battery (22 days with PowerPak)

Operating temperature LEL, CO and H2S sensors: -40° to +50° COther sensors: -20° to +50° C

Humidity 10 - 90% RH, non-condensing

IP Rating IP-65

Certi� cate VS and Canada: C1D1, Groups A, B, C, D, T4Europe: ATEX IM1/II 1G Ex ia I/IIC T4IECEX: Ex ia IIC T4Please contact RAE Benelux for country-speci� c certi� cates

RF Certi� cate FCC Part 15, CE, SRRC

RAE Benelux Belgium

Amsterdamstraat 28 2321 Hoogstraten

Telephone +32 (0)3 - 3138003 Fax +32 (0)3 - 293 42 46www.rae.be

RAE Benelux BV

Hoofdweg 34C 2908 LC Capelle a/d IJssel

Telephone +31 (0)10 - 442 6149 Fax +31 (0)10 - 442 6148 www.rae.nl

NEW