View Results of your Multiple Load Cases in a single Output Report 1

1

View Results of your View Results of your Multiple Load Cases in Multiple Load Cases in a single Output Reporta single Output Report

View Results of your View Results of your Multiple Load Cases in Multiple Load Cases in a single Output Reporta single Output Report

www.pipingsolutions.com

TRIFLEX® Windows

2

Multiple Load Cases – Multiple Load Cases – Single ReportSingle Report

•View Results of your Multiple Load Cases in a single Output Report.

•In TRIFLEX you can select the following reports: •Restraint Forces and Moments

•System Forces and Moments

•Anchor Forces and Moments

•Piping System Movements

•Anchor Movements

•Restraint Movements

•(more in the future)


TRIFLEX® Windows


3

Using Using TRIFLEX®Windows version 2.6.2 or greaterversion 2.6.2 or greater

This is only one example.

Now we want the Loads on Anchor Point 10 but, ALL load cases in one table

For comparison


TRIFLEX® Windows


4

Run the Analysis, then Run the Analysis, then Output, View Analysis Output, View Analysis

ResultsResults Output,

View Analysis Results.


TRIFLEX® Windows


5

Now choose Anchor Now choose Anchor Forces and Moments from Forces and Moments from

the Output Tablesthe Output Tables

Output Table,

Anchor Forces and Moments.


TRIFLEX® Windows


6

Control – Click, on the line Control – Click, on the line for Anchor Node Point 10for Anchor Node Point 10

Control - Click,

Anchor Node Point 10.


TRIFLEX® Windows


7

Click the radio button for, Click the radio button for, Order by Case.Order by Case.

Click,

Order By Case.


TRIFLEX® Windows


8

Note: the two additional buttons Note: the two additional buttons that are now added.that are now added.

Here I selected:

Show Base Operating Cases.


TRIFLEX® Windows


9

Note: the two additional buttons Note: the two additional buttons that are now added.that are now added.

Here I selected:

Show All Cases.


TRIFLEX® Windows


10

The User can now use this The User can now use this table for a Written Report.table for a Written Report.

The User can now copy this Table to his Final Written Report.

Using previous techniques developed in TRIFLEX®Windows.


TRIFLEX® Windows


11

But now we want the Vertical Loads onlyBut now we want the Vertical Loads onlyon Five Restraints. on Five Restraints.

But across all Load Cases.But across all Load Cases.

Now we will show a different example.

The Five Vertical Restraints shown with the Up Arrows.


TRIFLEX® Windows


12

Now choose Restraint Now choose Restraint Forces and Moments from Forces and Moments from

the Output Tablesthe Output Tables


TRIFLEX® Windows


13

Choose the Five Cells which Choose the Five Cells which correspond to the Vertical Load on correspond to the Vertical Load on

its associated Restraint.its associated Restraint.

Control Click to select each Cell


TRIFLEX® Windows


14

The Result for selected cells:The Result for selected cells:

The User can now copy this Table to his Final Written Report.

Using previous techniques developed in TRIFLEX®Windows


TRIFLEX® Windows


15

For more details please contact:

6219 Brittmoore Road

Houston, Texas 77041-5114 U.S.A.

Voice: 713 849 3366

Fax: 713 849 3654

: [email protected]

Documents

View Results of your Multiple Load Cases in a single Output Report 1