CRYSTAL CLEAR AUDIOWITHOUT ANY WIRES

User Manual

CRYSTAL CLEAR AUDIOWITHOUT ANY WIRES

Features

Specifications

Wireless stereo sound

Noise cancellation

Supports independent pairing

Play time of up to 5 hours

Standby time of up to 120 hours

Charging time of 1 hour

Built-in HD microphone

Bluetooth version: 4.2

Frequency: 2.4 Ghz

Wireless Range: 30 ft (~10m)

Receiver Sensitivity: -90 dBm

Battery Capacity: 65 mAh

Charging Cradle capacity: 1000 mAh

Supports CVC6.0 active noise cancellation

Supports A2DP1.3/HFP1.2/AVRCP1.6/DI1.3

CRYSTAL CLEAR AUDIOWITHOUT ANY WIRES

Please wear the wireless earphones like this.

CRYSTAL CLEAR AUDIOWITHOUT ANY WIRES

1. Turn the earphones off.

2. Simultaneously press and hold the button on both earphones for 8 to 10

seconds.

3. The LEDs on the earphones will begin to flash red and blue.

4. When the earphones have paired with each other, the LEDs on both earphones

will flash blue once.

5. Release the buttons on each earphone.

The linking relationship is saved for future use; you should only need to do this once.

Any two Stoned Earphones may be linked to each other; if you have more than one

pair of Stoned Earphones, you may freely mix them.

Linking the Stoned Earphones to each other

1. Turn the earphones off.

2. Hold the button down on one earphone until you hear a “pairing” chime.

3. Hold the button down on the other earphone until you hear a “power on”

chime.

4. Open your Bluetooth settings and pair with the Stoned Earbuds.

5. Enjoy the music!

(The earbuds may also be paired with a laptop or any other Bluetooth-capable host.)

Pairing the Stoned Earphones to a phone

CRYSTAL CLEAR AUDIOWITHOUT ANY WIRES

Put the earphones in the charging case. While charging, you’ll see a red LED. When

charging has finished, you’ll see a blue LED.

The charging case may itself be charged by plugging it into a USB power source.

Charging

Pause:

Next song:

Answer call:

End call:

Reject call:

tap the center button once.

tap the center button twice.

tap the center button once.

tap the center button once.

tap the center button twice.

The Button

1. Press the button on one earphone for 3 seconds until you hear a “power off”

chime.

Powering off the Stoned Earphones

CRYSTAL CLEAR AUDIOWITHOUT ANY WIRES

1. Don’t throw Stoned Earphones in the trash. The Stoned Earphones contain

lithium-ion polymer batteries, and must be disposed of at an an appropriate

facility.

2. Don’t subject the Stoned Earphones to excessive physical stress.

3. Don’t submerse the Stoned Earphones in water—the Stoned Earphones are not

waterproof.

Don’t do this