Upload
warren-coller
View
214
Download
0
Tags:
Embed Size (px)
Citation preview
UNITEDUNITEDNATIONSNATIONS
Konstantin Glukhenkiy
TIR Secretary
United Nations
Economic Commission for Europe
Regional TIR SeminarRegional TIR Seminar(Tunis, 3 and 4 June 2009)(Tunis, 3 and 4 June 2009)
Secure vehicles: Secure vehicles: Technical regulations regarding load Technical regulations regarding load
compartments and containerscompartments and containers
Regional TIR Seminar, Tunis, 3-4 June 2009
2
UNECE
APPROVAL OF ROAD VEHICLES APPROVAL OF ROAD VEHICLES (CONTAINERS)(CONTAINERS)
Basic principles• Goods cannot be removed from or introduced into the
sealed part of the vehicle or container without leaving obvious traces of tampering or without breaking the Customs seal
• Customs seals can be simply and effectively affixed to them
• There exist no concealed spaces where goods may be hidden
• All spaces capable of holding goods are readily accessible for Customs inspection
Regional TIR Seminar, Tunis, 3-4 June 2009
3
UNECE
APPROVAL OF ROAD VEHICLES APPROVAL OF ROAD VEHICLES (CONTAINERS) (cont’d)(CONTAINERS) (cont’d)
• By competent authorities• Individual approval or design type approval• Road vehicles: Renewal every 2 years• Containers: Approval for life
Regional TIR Seminar, Tunis, 3-4 June 2009
4
UNECE
APPROVAL OF ROAD VEHICLES APPROVAL OF ROAD VEHICLES (CONTAINERS) (cont’d)(CONTAINERS) (cont’d)
Vehicles: Approval certificate• Format A3, folded in two• Original to be kept on vehicle
Containers: Approval plate• Permanently affixed • Clearly visible • Adjacent to other approval plates
Approval Certificateof a road vehicle for the transport of goods
under Customs seal
Certificate No ……………….
NL/26/73
TYPE */ .......... MANUFACTURER'S NoOF THE CONTAINER ..........
Metal plate Container wall
*/ Only in case of approval by design type.
200 mm
10
0 m
m
APPROVED FOR TRANS PORTUNDER CUS TOMS S EAL
Regional TIR Seminar, Tunis, 3-4 June 2009
5
UNECE
SHEETED VEHICLES
Thong
Door hinges
Door closing system,lock and sealing device
TIR-ringsand eyelets
TIR-wire
Sideboard hinges
The sheet
Regional TIR Seminar, Tunis, 3-4 June 2009
6
UNECE
SHEETED TRUCKS AND TRAILERS
Special attention should be paid to:
• Damages
• Repairs
• Company logos
• TIR rings
• Eyelets
Regional TIR Seminar, Tunis, 3-4 June 2009
7
UNECE
SHEET
Rather extensive damage: this trailer should NOT be allowed to continue, unless it is
repaired
Regional TIR Seminar, Tunis, 3-4 June 2009
8
UNECE
SHEET
Minor damage: dependent on the commodity being
transported, this trailer COULD be allowed to complete the current journey - but should
NOT be able to carry out further international transport
without being repaired
Regional TIR Seminar, Tunis, 3-4 June 2009
9
UNECE
SHEET
Company logo covers a repair made incorrectly - sheet repaired by using an adhesive tape on the inner side of the
sheet (see also pages 160-161 of the TIR Handbook)
Regional TIR Seminar, Tunis, 3-4 June 2009
10
UNECE
SHEETED VEHICLES
Regional TIR Seminar, Tunis, 3-4 June 2009
11
UNECE
SHEETED VEHICLES
Regional TIR Seminar, Tunis, 3-4 June 2009
12
UNECE
SHEETED VEHICLES
Regional TIR Seminar, Tunis, 3-4 June 2009
13
UNECE
SHEETED VEHICLES:TIR RINGS
Regional TIR Seminar, Tunis, 3-4 June 2009
14
UNECE
SHEETED VEHICLES:TIR RINGS
Regional TIR Seminar, Tunis, 3-4 June 2009
15
UNECE
SHEETED VEHICLES:THONGS
Regional TIR Seminar, Tunis, 3-4 June 2009
16
UNECE
SHEETED VEHICLES:TIR RINGS, TIR WIRE AND THONGS
Regional TIR Seminar, Tunis, 3-4 June 2009
17
UNECE
SHEETED VEHICLES:THONGS
Regional TIR Seminar, Tunis, 3-4 June 2009
18
UNECE
THONGS SHOULD BE MADE OF ONE PIECE: NO REPAIRS!
Regional TIR Seminar, Tunis, 3-4 June 2009
19
UNECE
INADMISSIBLE EXAMPLES
Regional TIR Seminar, Tunis, 3-4 June 2009
20
UNECE
HINGES
Regional TIR Seminar, Tunis, 3-4 June 2009
21
UNECE
• The most vulnerable and frequently manipulated element
• Must be clearly visible at its entire length
• Must be made of steel of at least 3 mm diameter or hemp or sisal of at least 8 mm diameter. Nylon ropes are not permitted!
• Must be made of one piece only - no repairs, joints, etc.!
• Must have a hard metal end-piece at each end (p.162 of the Handbook)
• Length shall correspond exactly to what is required for each individual truck or trailer - no extra length shall be hidden anywhere, i.e. as loops between the TIR-rings
SHEETED VEHICLES: TIR WIRE
Regional TIR Seminar, Tunis, 3-4 June 2009
22
UNECE
TIR WIRE
Regional TIR Seminar, Tunis, 3-4 June 2009
23
UNECE
TIR WIRE
Regional TIR Seminar, Tunis, 3-4 June 2009
24
UNECE
TIR WIRE
Regional TIR Seminar, Tunis, 3-4 June 2009
25
UNECE
TIR WIRE
Regional TIR Seminar, Tunis, 3-4 June 2009
26
UNECE
TIR WIRE
Regional TIR Seminar, Tunis, 3-4 June 2009
27
UNECE
TIR WIRE
Regional TIR Seminar, Tunis, 3-4 June 2009
28
UNECE
TIR WIRE
Regional TIR Seminar, Tunis, 3-4 June 2009
29
UNECE
TIR WIRE
Regional TIR Seminar, Tunis, 3-4 June 2009
30
UNECE
TIR WIRE
Regional TIR Seminar, Tunis, 3-4 June 2009
31
UNECE
DOORS, OTHER CLOSING SYSTEMS AND CUSTOMS SEALING DEVICES
• Doors and all other closing systems shall be fitted with a device on which Customs seals can be fixed
• This device cannot be removed and replaced from the outside without leaving obvious traces, or the door or fastening be opened without breaking the Customs seals
• The sealing device must be secured by welding, or by not less than two special joining devices
• The sealing device must incorporate holes of not less than 11 mm in diameter or slots of at least 11 mm in length by 3 mm in width, and afford equal security whatever type of seal is used
Regional TIR Seminar, Tunis, 3-4 June 2009
32
UNECE
SECURE CUSTOMS SEALING
• TIR wire is not longer than necessary and is properly tightened
• Customs seals are affixed as tight as possible
• In a combination “sheeted vehicle - rear doors” both the TIR wire and door closing system should be secured. If the TIR wire does not pass through the pivoting device/ manoeuvre handle, extra seals are required
• Due to wear and tear of sealing device details, the security of Customs sealing can go down
Regional TIR Seminar, Tunis, 3-4 June 2009
33
UNECE
SECURE DOOR
CLOSING SYSTEM
Regional TIR Seminar, Tunis, 3-4 June 2009
34
UNECE
DOOR CLOSING SYSTEM
Regional TIR Seminar, Tunis, 3-4 June 2009
35
UNECE
DOOR CLOSING SYSTEM
Regional TIR Seminar, Tunis, 3-4 June 2009
36
UNECE
DOOR CLOSING SYSTEM
Regional TIR Seminar, Tunis, 3-4 June 2009
37
UNECE
DOOR CLOSING SYSTEM
Regional TIR Seminar, Tunis, 3-4 June 2009
38
UNECE
DOOR CLOSING SYSTEM
Regional TIR Seminar, Tunis, 3-4 June 2009
39
UNECE
TIR Convention
UNECE/TIR SECRETARIAT
8-14, Avenue de la PaixCH-1211 Geneva 10
Switzerland
Phone: +41 22 917 15 31
Fax: +41 22 917 06 14Email address: [email protected]
http://tir.unece.org
Regional TIR Seminar, Tunis, 3-4 June 2009
40
UNECE
THANK YOU