THE WAY TO MAKE ITTHE WAY TO MAKE IT

The motorized feed allows different conductors and compaction lengths to be processed in a sequence without changeover.The process parameters can be set quickly and easily right in the TopWin user interface or using the modern touch interface from Schunk.Quality data are visualised and clearly presented on the panel. Komax is happy to produce samples incorporat-ing the processing you desire.

Mode of operationUltrasonic welding is a mature and optimized process thanks to the years of experience Komax and Schunk have in this field. The conductor being compacted is put under slight pressure and compacted by means of high frequency mechanical vibrations. In a fraction of a second, this process creates a strong and permanent bond that is metallurgically pure and has excellent electrical conducting properties.

Technical data

Device type for Alpha 35x and Zeta 633:

Minic-MV-20 Servo-TP PLUS

Conductor cross section: Up to 6 mm²Optionally up to 16 mm²

Processing material: Copper, aluminium

Compaction length: 4 – 20 mm

Geometry: Rectangular/square

Operating frequency: 20 kHz

Power rating: 3000 W

Network voltage: 3 L/N/PE V AC 400 V16 A, 50/60 Hz

Output rate: 840 – 1750 pcs/hDepends on application and conductor

0310

473

– Ve

rsio

n 1

Your benefits•Excellent electrical properties•Comprehensive process monitoring•Different types of compaction in same sequence•Excellent alternative to end sleeves• Input of process parameters in TopWin•Usable on Alpha 355 S / 356 / Zeta 633

www.komaxwire.com

Ultrasonic welding processAlpha 355 S / 356 / Zeta 633