Upload
others
View
4
Download
0
Embed Size (px)
Citation preview
Installation guide
Multi Ejector (spareparts: ejector and strainer) Type CTM 1, CTM 2, CTM6
032R
9791
032R
9791
© Danfoss | DCS (az) | 2018.06 DKRCC.PI.VM0.B2.02 | 1
English
1
3
2
4
Danfoss32F1007.20
Allen key 5 mm
Danfoss32F1008.10
5 6
Service on strainer
Remove strainer from valve body Dismount strainer
Allen key 5 mm
Allen key 5 mm
Allen key 5 mmTorque 6 Nm ± 1
Clean / replace strainer/replace O-ring
Mount strainer with screws
Assemble strainer
Oil O-rings and place strainer in valve
= compressor oil
Danfoss32F897.10
A
B
C
D
Danfoss32F898.20
8
Allen key 5 mm
7
Danfoss32F899.10
Tighteninig sequence
Allen key 5 mmTorque 10 Nm ± 1
© Danfoss | DCS (az) | 2018.06 DKRCC.PI.VM0.B2.02 | 2
1
3
2Danfoss32F1011.20
Allen key 5 mm
Danfoss32F1012.10
Danfoss32F1013.10
Service on ejector
Remove ejector from valve body Replace complete ejector
Oil O-rings and place ejector
Danfoss32F877.20
1
3
2
Remove strainer from valve body
Dismount strainer
5 mm allen key
Torque 6 Nm ± 1
Clean or replace strainerand replace O-ring
5 mm allen key45 6
Assemble strainer Oil O-rings and placestrainer in valve
Mount the strainerwith screws
7
8
A
B
C
D
1
3
2
Danfoss32F855.10
A
B
C
D
Remove ejector from valve body Replace complete ejector Mount the ejector with screws Oil O-rings and place ejector
= compressor oil
Allen key 5 mm
Allen key 5 mm
Allen key 5 mmTorque 10 Nm ± 1
Allen key 5 mmTorque 10 Nm ± 1
Tightening sequence
Allen key 5 mmTorque 10 Nm ± 1
Mount the ejector with screws
Allen key 5 mm