1
PRODUCT DATA SHEET In support of our policy of continuous product improvement we reserve the right to change materials and specifications without notice. Drawings, where used, are not to scale. All dimensions are in millimetres and sizes given are approximate. Where possible, technical msds data sheets are made available on the website. All products should be installed and used in accordance with manufacturer's instructions provided. Warning: products may be the subject of registered designs and patents. Refer to website for terms and conditions on warranty. T: POWER 1800 769 370 T: MSS POWER SYSTEMS 03 9839 3500 | E: [email protected] W: cabacpower.com.au W: msspower.com.au TWIST-LOCK ELECTRONIC PHOTO CONTROL HS6390B / HS6390B-C HS6390B/ HS6390B-C The HS6390B and HS6390B-C are light sensing switch for controlling mains powered street lighting, designed to switch ON at low light levels and OFF at high light levels. The difference between the HS6390B and the HS6390B-C is the C version uses cadmium sulfide photocell. These twist-lock electronic photo control features rugged design and are available in two standard models of sensing technology, with options to satisfy a wide variety of applications. Part No: HS6390B/ HS6390B-C FEATURES Double-Sided Plated-Through Circuit Board (DSPT) for durability and reliability Quad-Gate Technology for precision and consistency Full Wave Rectification Dual Zener Diodes 320 Joule MOV High Impact Thermoplastic Base Solid Brass Contact Blades UV Stabilized Permanent Colour High Impact Resistant Polypropylene Cover Conforms to AS1158-6 CHARACTERISTICS All specifications apply at a T amb of +25°C unless otherwise specified. Parameter HS6390B HS6390B-C Nominal supply voltage 50 /60 Hz 120/ 208/ 240/ 277 Vac 120/ 208/ 240/ 277 Vac Supply voltage range 105 - 305 Vac 105 - 305 Vac Failure Mode ON ON Load Rating 1000 Watt Tungsten / 1800 VA Ballast 1000 Watt Tungsten / 1800 VA Ballast Operating Temperature -40°C to +70°C (-40F to +158F) -40°C to +70°C (-40F to +158F) Photocell Encapsulated Silicon Photo transistor Cadmium Sulfide Dielectric Strength 5000 Volts between current carrying parts and metal surfaces 5000 Volts between current carrying parts and metal surfaces Surge Protection 320 Joule MOV/10,000 amp surge current 320 Joule MOV/10,000 amp surge current Power consumption 0.85 Watts @ 240V 0.85 Watts @ 240V Time Delay Off (Instant ON) 3 to 5 seconds 3 to 5 seconds Operating Light Levels (1) (Standard Settings) Turn on 16 Lux ± 3 Lux / Turn off by 25 Lux (Off: On ratio = 1.5:1) Turn on 16 Lux ± 3 Lux / Turn off by 25 Lux (Off: On ratio = 1.5:1) ANSI Colour Coded Cover Blue (Standard) Blue (Standard) (1) Light level can be set to individual customers requirement. Page 1 of 1

TWIST-LOCK ELECTRONIC PHOTO CONTROL · • Double-Sided Plated-Through Circuit Board (DSPT) for durability and reliability ... Load Rating 1000 Watt Tungsten / 1800 VA Ballast 1000

  • Upload
    others

  • View
    52

  • Download
    0

Embed Size (px)

Citation preview

Page 1: TWIST-LOCK ELECTRONIC PHOTO CONTROL · • Double-Sided Plated-Through Circuit Board (DSPT) for durability and reliability ... Load Rating 1000 Watt Tungsten / 1800 VA Ballast 1000

PRODUCT DATA SHEET

In support of our policy of continuous product improvement we reserve the right to change materials and specifications without notice. Drawings, where used, are not to scale. All dimensions are in millimetres and sizes given are approximate. Where possible, technical msds data sheets are made available on the website. All products should be installed and used in accordance with manufacturer's instructions provided. Warning: products may be the subject of registered designs and patents. Refer to website for terms and conditions on warranty.

T: POWER 1800 769 370 T: MSS POWER SYSTEMS 03 9839 3500 | E: [email protected] W: cabacpower.com.au W: msspower.com.au

TWIST-LOCK ELECTRONIC PHOTO CONTROL HS6390B / HS6390B-C

HS6390B/ HS6390B-C

The HS6390B and HS6390B-C are light sensing switch for controlling mains powered street lighting, designed to switch ON at low light levels and OFF at high light levels.

The difference between the HS6390B and the HS6390B-C is the C version uses cadmium sulfide photocell. These twist-lock electronic photo control features rugged design and are available in two standard models of sensing technology, with options to satisfy a wide variety of applications.

Part No: HS6390B/ HS6390B-C

FEATURES• Double-Sided Plated-Through Circuit Board (DSPT)

for durability and reliability• Quad-Gate Technology for precision and consistency• Full Wave Rectification• Dual Zener Diodes• 320 Joule MOV• High Impact Thermoplastic Base• Solid Brass Contact Blades• UV Stabilized Permanent Colour• High Impact Resistant Polypropylene Cover• Conforms to AS1158-6

CHARACTERISTICSAll specifications apply at a Tamb of +25°C unless otherwise specified.

Parameter HS6390B HS6390B-CNominal supply voltage 50 /60 Hz 120/ 208/ 240/ 277 Vac 120/ 208/ 240/ 277 Vac

Supply voltage range 105 - 305 Vac 105 - 305 Vac

Failure Mode ON ON

Load Rating 1000 Watt Tungsten / 1800 VA Ballast 1000 Watt Tungsten / 1800 VA Ballast

Operating Temperature -40°C to +70°C (-40F to +158F) -40°C to +70°C (-40F to +158F)

Photocell Encapsulated Silicon Photo transistor Cadmium Sulfide

Dielectric Strength5000 Volts between current carrying parts and metal surfaces

5000 Volts between current carrying parts and metal surfaces

Surge Protection 320 Joule MOV/10,000 amp surge current 320 Joule MOV/10,000 amp surge current

Power consumption 0.85 Watts @ 240V 0.85 Watts @ 240V

Time Delay Off (Instant ON) 3 to 5 seconds 3 to 5 seconds

Operating Light Levels (1)

(Standard Settings)Turn on 16 Lux ± 3 Lux / Turn off by 25 Lux (Off: On ratio = 1.5:1)

Turn on 16 Lux ± 3 Lux / Turn off by 25 Lux (Off: On ratio = 1.5:1)

ANSI Colour Coded Cover Blue (Standard) Blue (Standard)

(1) Light level can be set to individual customers requirement.

Page 1 of 1