Upload
others
View
8
Download
0
Embed Size (px)
Citation preview
English
Triple C-Clamp Monitor Mount
22LBS
VESA100x100
75x75
Up to 24”
Assembly Instructions
©2017 NavePoint,LLC
Thank you for purchasing a NavePoint product. If you have any questions regarding the installation or use of your product, please call us at 888.505.1363.
Please examine the product for any damaged parts. If any part is damaged or missing, contact NavePoint for assistance. Do not attempt to install or use product if it has been damaged.
During installation, lay product contents on cardboard or other protective surface to avoid any damage.
Improper installation of this product could result in damage to the product, other equipment, or personal injury. It is recommended that installation be
damage to equipment or personal injury resulting from improper use or installation of product.
Limitations of Liability: In no event will NavePoint, LLC. be liable for any damages, whether direct or indirect, special, punitive, incidental or conse-
of use, lost business opportunities or loss of goodwill) or for the costs of procuring substitute products, arising out of or in connection with the use of the product, whether such liability arises from any claim based upon contract, warranty, tort (including negligence), product liability or otherwise, whether or not seller has been advised of the possibility of such loss or damage. In no event will seller’s total cumulative liability, from all causes of action and all theories of liability, exceed the total amounts actually paid to seller by customer under the order that gives rise to any liability hereunder.
2
WARNING
CAUTION!This monitor desktop mount must be securely attached to the horizontal desk. If the mount is not properly installed it may fall, resulting in possible injury and/or damage.
3
Tools Required Phillips Screwdriver
(12)M4 Space-g(12)M4x30 Bolt-e (24)M4 Washer-f
(2)M8x10 Bolt-h (2)M10x15 Bolt-i (1)Allen Key-j (2)Spare PlasticCover-k
(1) 48mm TubeSupport-a
(1) VESA Plate withArm Assembled-c
(1) Disconnected“C” Clamp-b
(1)Wrench-l
(12)M4x12Thumb Bolt-d
Supplied Parts List
www.NavePoint.com [email protected]
Step 1
4
Step 2
a
b
i
j
c
h
Install arm (c) to tube support (a) while making sure that the wire clips on arm are facing down. Fasten the bolts (h) with screwdriver.
The depth of “C” clamp can be changed in three positions. Choose the proper depth according to the thickness of your desktop. Connect it to tube support (a) with 2pcs M10x15 bolts (i), using the supplied Allen Key (j). Tighten or loosen the tension knobs (b) to ensure a tight connection to desk.
www.NavePoint.com [email protected]
Install the “C” Clamp According to the Desktop Thickness
Install Arm to the Tube Support
5
Step 3
Step 4
Step 5
ef
g
l
j
j
df
Manage the wires using the wire clips. Some wires can be hidden inside the pipe.
Remove the plastic covers and use the Allen Key (j) to adjust the turning tension.
Change the tilt angle
Remove the plastic covers and adjust the nut with the Wrench (l) to change the tilt angle.
Turn the bolt counterclockwise to lower the center monitor, turn the bolt clockwise to raise the center monitor.
For monitor with flat back For monitor with curved back
Level Adjustment
Mount the Monitors to the VESA Plates
Manage the Wires and Adjust the Turning Tension
Fix the Tilt Angle and Adjust the Level of the Monitors
www.NavePoint.com [email protected]