Transmission Protection Course

7/29/2019 Transmission Protection Course

http://slidepdf.com/reader/full/transmission-protection-course 1/4

Organized by :- Total Power Solutions Sdn. Bhd. E-mail : tops @ tops-sb.com

COURSE SUMMARY

Due to the complex and difficult nature of the topic of protection, it has always been a subject that most

engineers are not conversant with. Most engineers place great emphasis on becoming competent on

primary equipment so much so that the secondary systems protection, telecontrol & telecommunications

go largely ignored. This course presents an opportunity for engineers to reinforce their knowledge in this

field.

The course is designed for electrical engineers who desire a working knowledge in transmission system

protection. This course would provide a clear insight into the practical aspects involved in the principles,

application, design and operation of protection schemes/devices for transmission networks (HV & EHV

systems and equipment).

The participants of this course will understand the causes, types and implications of faults that can occur in

a power systems. The course will also elaborate on the various protection schemes and devices available for

detecting these faults and their operating principle. The issue of power system stability and its importance

for efficient operation of the transmission system will be discussed .

The course will also provide a broad overview on numerical protection relay technology and the benefitsthey provide in ensuring a reliable and safe power system.

A 3 day training programme on:

TRANSMISSION GRID SYSTEMTRANSMISSION GRID SYSTEMTRANSMISSION GRID SYSTEMTRANSMISSION GRID SYSTEM

PROTECTIONPROTECTIONPROTECTIONPROTECTION

For NonFor NonFor NonFor Non----Protection EngineersProtection EngineersProtection EngineersProtection Engineers

On : June 19th to 21st, 2013

9.00 a.m. to 5.30 p.m.

At : Best Western Premier, Dua Sentral

Transformer

ProtectionBusbar

Protection

Feeder

Protection

PastParticipant’s

Feedback

Great lecturer.Gave me a

solidunderstandingon protection.

Good for understandingfundamentalsof protection

philosophies &relays

Excellent for beginners

Expert Trainers:

Dr. G. Pradeep KumarDr. G. Pradeep KumarDr. G. Pradeep KumarDr. G. Pradeep Kumar

Dr. M. Tamije SelvyDr. M. Tamije SelvyDr. M. Tamije SelvyDr. M. Tamije Selvy



Inter active

with

illustr ations

Case

Stud

ies

Expert Trainer

Dr. G. PRADEEP KUMARB. Eng in Electrical and Electronics Engineering, University of Madras (1995)

Ph.D in Power System Protection, University of Western Ontario (2006)

Member of IEEE, IET & CIGRE

He has a wide range of industrial and academic experience in the field of power system protection and

automation, spanning over a decade and half. His work experiences include:

GEC, Alsthom - testing and commissioning engineer, application engineer, marketing engineer, service

manager and application manager.

University of Waterloo, Canada - developed and conducted on-line power system protection course for the

post graduate degree.

Protection Engineering And Research Laboratories (PEARL), Chennai - trained more than 750 engineers

from utilities across Asia including Tenaga Nasional Berhad on various topics in power system protection.

Work experience of over 18 years, has helped in developed an array of skills in application, research,

development and training. His skill sets include:

• Providing expert technical advice & solution in power system protection design, application & engineering

• Protection device setting and co-ordination for Transmission, Generation and Industrial power systems

• Research and development of numerical protection relay algorithms

• Conducting training courses in subjects related to power system covering areas of design, application,

operation & testing

• Scheme engineering

• Site investigation & troubleshooting

Transmission Grid System Protection For

Non-Protection Engineers

Expert Trainer

Dr. M. TAMIJE SELVYB. Eng in Electrical & Electronics Engineering, Pondicherry Engineering College (1998),

M. Eng Power System Protection, University of Saskatchewan (2000),

Ph.D in Software Modeling of Relays, University of Western Ontario (2006),

Member of IEEE

With a combination of power system and software knowledge, she has extensive experience in software

modeling of protection relays, simulation of power systems, research and development of numerical

protection relay algorithms and development of power system related software applications, spanning close

to a decade.

The 13 years of academic and industrial experience has enabled her to acquire skills in multiple disciplines.

Her skill sets include,

• Protection system application

• Software modeling of relays

• Simulation of power systems

• Research and development of numerical protection relay algorithms

• Development of power system related software applications

• Post fault analysis

FOR REGISTRATION, PLEASE CALL (03) 2302 1525 , FAX (03) 2302 1528 or EMAIL [email protected]



Session Topics

Day 1

Morning Session

Introduction to Transmission System Protection

• Faults in power system: types, cause and effect

• Nature of power system signals during fault

• Types of system grounding and its effect on faulted signals

• Building blocks of the protection system

• Main & back-up protection

Lunch break

Afternoon

Session

Introduction to Protection Schemes & Relays

• Types of protection devices

• Building blocks of numerical protection relay• Overview of hardware and software of numerical relays

• Features and advantages of numerical relays

END

Day 2

Morning SessionProtection System Building Blocks

• Current and voltage transformer

• Auxiliary supply system and monitoring

• Tripping system and monitoring

Lunch break

Afternoon

Session

Transmission System Operation & Stability• Issue of stability in power system

• Critical fault clearing times & stability limits

• Power swings in electrical systems

• Voltage, Frequency & Angle stability

END

Day 3

Morning Session

Principles for Substation Protection

• Busbar Protection Schemes

• Transformer Protection Schemes

• Breaker Failure Protection

• Interlocks

Principles for Transmission Lines & Cables Protection

• Distance protection for EHV/ HV lines

• Current differential protection

• Backup protection for HV lines

Lunch break

Afternoon

Session

Back-up Protection of Transmission Lines & Cables

• Types of short circuit protection devices

• Types of ground fault protection devices

• Over current and earth fault relays and co-ordination

Open Discussion & Feedback Session

END



Who Should Attend?

This is an ideal course for

electrical engineers who

have no prior knowledge /

experience in protection.

Young electrical engineers

with no or very little work

experience will find this

course as a very good

introduction to the field of power transmission system

protection.

Professionals with

considerable experience in

areas not directly related to

protection (like operation,

maintenance, project

management, contracts,

system operator etc) will

gain valuable knowledgethat would equip them with

good cross functional

competence.

C o u r s e O u t l i n e




REGISTRATION FORM

Name: ___________________________

Position: ___________________________

Mobile No: ___________________________

Email: ___________________________

Name: ___________________________ Position: ___________________________

Mobile No : ___________________________

Email: ___________________________

Name: ___________________________

Position: ___________________________

Mobile No : ___________________________

Email: ___________________________

Company: ___________________________

Business Nature: ___________________________

Contact Person: ___________________________

Email: ___________________________

Address: ___________________________

___________________________

___________________________

Office Tel: ___________________________

Office Fax: ___________________________

Approver’s Name: ___________________________ Designation: ___________________________

Authorized Signature Company Stamp

Confirmation Policy

Confirmation of registration and trainingdetails will be sent to you within 7 calendar

days from receipt of your registration.

Substitution of participant is allowed.

Cancellation Policy Any cancellation must be in writing by mail,

fax or email prior to the training date subject

to the refund conditions below :-

at least 14 calendar days notice - fullrefund.

7 to 14 calendar days notice - a 10%

administrative fee will be imposed.

less than 7 calendar days notice – no

refund

Training fees includes training materials,

2 coffee breaks & 1 lunch meal/buffet

per day and trainer's fee. The trainer and

topics are confirmed at the time of

publishing. TOPS reserves the right toalter or modify the advertised

speaker/topics under circumstances

beyond the control of TOPS.

Participant’s Fees

Individual RM 2, 800 /pax

Group * RM 2, 500 /pax

* for 3 pax & above

For further enquiries : -

+6 019 330 0861 Jenny

+6 012 678 9302 Ganesh

Please fill in the registration form and

return it with a cheque/ bank draft to

"Total Power Solutions Sdn. Bhd.”

Where : Best Western Premier,

Dua Sentral, Brickfields

When : June 19th – 21st, 2013




Suite A-15-3, Menara UOA Bangsar,

No. 5, Jalan Bangsar Utama 1,

59000 Kuala Lumpur

Sr. No. 4196

Documents

Transmission Protection Course