you should line up

the screen

protector and

make sure that

every things fit.

Our films are cut accurately for easier

installation

Wet Tissue Cleaning Cloth

Clean the screen using the cleaning cloth or a wet tissue , if tissue

is too dry you can use a drop of water to make sure its moisten.

Dust and dirt is the

No.1 cause for

bubbles appearing

underneath, so

ensure the screen

is completely

clean.

Once the screen is clean..

Peel the label mark

No.1, this is the side

that goes on to the

screen,

Avoid touching the back of the screen protector to avoid

fingerprints,

Align the screen protector while you do

the installation.

Just peel of the label mark

no.2 and

You are done.

Don’t worry.,

first peal back the screen protector, use the piece of sticking tape and tap on the dust, on the screen and on the screen protector, unless fully free from dust.

If the film doesn't not sticks from the Label No.1 direction, try sticking the Screen Protector from the Label No.2 direction.

Rarely No.1 Label may be placed on the No.2 side, and to avoid wastage, film can be examined by inspection it’s surface on the screen.

For Further Queries Contact :

Aashish Kumbhat

+91 9840203040

aashish@inbasetech.com