Embed Size (px)
Citation preview
Ope
rato
r’s M
anua
l
THIS IS A MANUAL PRODUCED BY JENSALES INC. WITHOUT THE AUTHORIZATION OF SAME OR IT’S SUCCESSORS. SAME AND IT’S SUCCESSORS
ARE NOT RESPONSIBLE FOR THE QUALITY OR ACCURACY OF THIS MANUAL.
TRADE MARKS AND TRADE NAMES CONTAINED AND USED HEREIN ARE THOSE OF OTHERS, AND ARE USED HERE IN A DESCRIPTIVE SENSE TO REFER TO THE PRODUCTS OF OTHERS.
Operator’s Manual
Tiger 100 2 & 4 Wheel Drive
SAM-O-TIG100
Fi'g. 5 Tractor top view 1 Hydrostatic steering gear jack 2 ,platform
3 Roll frame 4 Fuel tank cap 5 Front grill fastening screws 6 Controls
7
CONTROLS
Mechanical Controls
Gearshift Plate (1, Fig. 6)
This plate indicates the gearshift and reduction gear levers' positions. Your tractor has four forward and one reserve gears. Its reduction gear allows three different reduction rates: slow, medium, fast. Consequently, three different transmission ratios are available for each gear, resulting in the following gear sequence, in which gears are listed according to an increasing speed sequence:
Fig . 6 1 Gearshift plate
2 Reduction ,gear lever
3 Gearshift leve;r
4 Differential locking pedal
8
Low 2nd 3rd 4th 5th 6th 7th 8th 9th 10th 11 th High Low rev. 2nd rev. High rev.
Slow
I II
III IV
Rev.
Medium
I II
III VI
Rev.
Fast
I II
III IV
Rev.
Reduction ear Lever (2, Fig. 6)
Its positions are shown on plate (1, Fig. 6).
Gearshift Lever (see 3, Fig . 6)
Your tractor's speed is determined
5 Automatic control unit control handle 6 Automatic control ,unit setting handle 7 Auxiliary distributor control handle 8 Auxiliary distributor control handle 9 PTa engaging handle
Fig. 7 Mechanical Controls - left-Hand Side 1 Parking brake lever 2 Front wheel ;drive engaging lever (4 RM
tractors o'nly) 3 Seat spring adjusting handle 4 Seat spring adjustment pointer
10
Fig. 8
Mechanical Controls - Right-Hand Side 1 Seat back-and-forth adjusting h9.<Tldle 2 ,Hand throttle control
11
