28/3/2014 TEMA Standards Updates
http://www.tema.org/users/updates.asp 1/1
TEMA STANDARDS UPDATES
The following pages have been updated. The version number
corresponds to the first three digits of the serial number ofyour
book. For example, if you have 902 as your first three digits, then
an update labeled 901 or 902 does not apply to
you since it is already included in your copy (and therefore is
not shown here), but a 903 or higher update does apply.
Version Page Description of Change
901 5.11-2 Paragraph RCB-11.4 (which is the same as it was in
the Eighth Edition) hadbeen inadvertently left out.
902 10-21 Paragraph RGP-RCB-10.7 revised: (d2t) should be (d2t)
in three places
903 2-3 Dimension R3 was shown as 1/4" but should be 1/16"
903 3-7 G-7.13 REFERENCE (12) Moss, Dennis R., "Pressure Vessel
Design Manual," 1987, Gulf
Publishing Company.Changed to:(12) Moss, Dennis R., "Pressure
Vessel Design Manual: IllustratedProcedures for Solving Major
Pressure Vessel Design Problems Edition: 3,Publisher: Gulf Pub Co
(December 18, 2003)
903 10-20 Mr in figure RGP-RCB-10.6 changed to Mt for
consistency with RGP-RCB-10.7
904 2-3 Figure F-3, in thetop section,
dimension D1shown in leftmost part of Standard
Confined JointConstruction was
pointing at thewrong corner.
Was: Should be:
906 5.4-2, 5.4-3 In Tables R-4.41 and CB-4.41 the conversion of
5/16" should be 7.9 mmnot 7.5 mm
909 5.4-3 In Table CB-4.41, bottom row, the conversion of 5/8"
should be 15.9 mm
not 12.7 mm
User Area Index
