SERVICE NOTE

TD-0045

REVISION 02CONTAINER MANAGEMENT

TD-0045.E.02-CONTAINER MANAGEMENT Last printed on 3-Jun-13 : 4/13

III. MARKING A CONTAINER

a) MARKING REQUIREMENTS

1) 0-00029498: paper tape

2) 0-00164891: white paint RAL9016

3) 0-00041323: Letter stencil 10 cm

4) 0-00041320: Number stencil 10 cm

5) 0-00590606: round JDN Sticker (34 cm diameter)

6) 0-00225510: black paint Sigmarine 40 8000 5L

7) 0-00816865: substitute paint roller 10cm

8) 0-00029513: paint roller handle 10cm

b) PLACE OF IDENTIFICATION ON CONTAINERS

1) The numbers and letters should be 10 cm in height, according to ISO standard 6346. They are

sprayed on in black on a clearly outlined white text field (2 coats to provide sufficient

coverage). We do not use letter stickers as the paint is more resistant to heat or rain.

2) The JDN number and the full CSC number (i.e. including the four-digit prefix) are to be

mentioned on each of the four surfaces.

a. The JDN number is always painted on the left side of the container

i. without spacing

ii. with a hyphen in case of WS, DN, ZL, SL or FL numbers

b. The CSC number is always painted on the right side of the container.

i. without spacing

ii. without a hyphen

3) The white text fields which are attached to the beam for this purpose cover the full width of

the beam, start from the edge of the container and run 148cm to the bottom (just above the

third hinge of the container door)

SERVICE NOTE

TD-0045

REVISION 02CONTAINER MANAGEMENT

TD-0045.E.02-CONTAINER MANAGEMENT Last printed on 3-Jun-13 : 5/13

4) The JDN sticker is applied in the left upper corner of each field.

5) In case of closed containers the CSC number is also sprayed onto the roof.

6) The identification is always applied vertically,

a. except at the side where the container

doors are situated

b. unless it is easier to apply them

horizontally due to the ribbed profile

of the container.

SERVICE NOTE

TD-0045

REVISION 02CONTAINER MANAGEMENT

TD-0045.E.02-CONTAINER MANAGEMENT Last printed on 3-Jun-13 : 6/13

7) On the container doors the location of the white fields depends on the type of container. See

example in the photo:

a. left: JDN number

i. spread over two lines for MOB numbers (MOB + the four digits on the

second line)

ii. spread over two lines and with a hyphen for WS, DN, SL, ZL or FL numbers

(e.g. WS + WS serial number and on the second line a hyphen + 3 digits)

b. Left door between the bars: JDN sticker

c. Right door between the bars: letters of the CSC number

d. Right: numbers of the CSC number

8) In case of collapsible flatrack

containers the CSC number is

to be applied horizontally at

the bottom side, so the

number is visible when

folded. But in accordance

with other containers the

number is to be applied on

the right beam, as well.