9628 Valley Blvd. Rosemead, CA 91770 | Phone 626-579-3288 | [email protected] SWH Racking System Data Sheet Version 12.10.v2 Splice bar material: 6005-T5 extruded aluminum alloy Finish: Clear or black anodized Self-tapping screw material: 304 stainless steel Splice bar weight: 0.32 lbs A thermal break is required every 40 feet of continously connected rail. For additional concerns on thermal breaks in your specific project, please consult a licensed structural engineer. Expansion joints prevent buckling of rails due to thermal expansion. Splice bars may be used for thermal expansion joints. To create a thermal expansion joint, slide the splice bar between the rail segments. Secure the splice bar with two screws on one side only. Footings (such as L-brackets or standoffs) should be secured normally on both sides of the splice. No PV module or mounting hardware component should straddle the expansion joint. • • • • • • SWH 6” F Splice Bar for Standard Rail & Ecolite Rails MFG-PN: MR-SW-SB-03M, MR-SW-SB-03B SWH Ecolite Rail 6” F Splice bar Self-tapping screws SWH Standard Rail 6 inches

SWH Standard Rail SWH Ecolite Rail

Download PDF Report

Upload
others
View
12
Download
0

Embed Size (px)

Citation preview

Page 1: SWH Standard Rail SWH Ecolite Rail

9628 Valley Blvd. Rosemead, CA 91770 | Phone 626-579-3288 | [email protected]

SWH Racking System Data Sheet Version 12.10.v2

Splice bar material: 6005-T5 extruded aluminum alloyFinish: Clear or black anodizedSelf-tapping screw material: 304 stainless steelSplice bar weight: 0.32 lbs A thermal break is required every 40 feet of continously connected rail. For additional concerns on thermal breaks in your specific project, please consult a licensed structural engineer.Expansion joints prevent buckling of rails due to thermal expansion. Splice bars may be used for thermal expansion joints. To create a thermal expansion joint, slide the splice bar between the rail segments. Secure the splice bar with two screws on one side only. Footings (such as L-brackets or standoffs) should be secured normally on both sides of the splice. No PV module or mounting hardware component should straddle the expan-sion joint.

•••••

•

SWH 6” F Splice Barfor Standard Rail & Ecolite Rails

MFG-PN: MR-SW-SB-03M, MR-SW-SB-03B

SWH Ecolite Rail

6” F Splice bar

Self-tapping screws

SWH Standard Rail

6 inches

CONFORMS TO UL SUB 2703

4009330