Upload
niakinezhad
View
213
Download
0
Embed Size (px)
Citation preview
7/30/2019 SVS_301605_TD_EN_V1-0_2CDC501036D0201
1/2
11
SV/S 30.160.5SV/S 30.160.5
ABB i-bus EIB / KNX EIB / KNX Power Supply, 160 mA, MDRC
SV/S 30.160.5, 2CDG 110 085 R0011
Page 1 of 2SVS_301605_TD_EN_V1-0
2CDC 501 036 D0201
The EIB / KNX Power Supply produces
and monitors the EIB / KNX system
voltage. The bus line is decoupled from
the power supply with the integratedchoke.
The power supply is connected to the
bus line with a bus connection termi-
nal. A reset is triggered by removing
the bus connection terminal for approx.
20 seconds.
The bus line is disconnected from the
power supply and the bus devices
connected to this bus line are returned
to their initial state.
Technical data
2CDC0
71056F0007
Power supply Power supply
Power consumption
Power loss
230 V AC +10/15%, 45 ... 65 Hz
< 8 VA
< 3 W
Outputs EIB / KNX output
EIB / KNX output voltage
Nominal current
Sustained short-circuit current Mains failure back-up time
1 line with integrated choke
30 V DC +1/2 V, SELV
160 mA, short-circuit-proof
< 450 A200 ms
Operating and display elements Green LED ON: Device in operation
Connections Power supply
EIB / KNX output
3 screw terminals
Cable cross-section:multi-core 0.2 2.5 mm2
single-core 0.2 4.0 mm2
Bus connection terminal (black/red)
Type of protection IP 20, EN 60 529
Ambient temperature range Operation
Storage
Transport
5 C ... + 45 C
25 C ... + 55 C
25 C ... + 70 C
Design Modular installation device, proM
Housing, colour Plastic housing, grey
Mounting On 35 mm mounting rail,DIN EN 60 715
Dimensions 90 x 72 x 64.5 mm (H x W x D)Mounting depth/width 68 mm/4 modules at 18 mm
Weight 0.21 kg
Certification EIB / KNX-certified
CE norm In accordance with the EMC guideline
and the low voltage guideline
7/30/2019 SVS_301605_TD_EN_V1-0_2CDC501036D0201
2/2
1 1
SV/S 30.160.5SV/S 30.160.5
ABB i-bus EIB / KNX EIB / KNX Power Supply, 160 mA, MDRC
SV/S 30.160.5, 2CDG 110 085 R0011
Page 2 of 2SVS_301605_TD_EN_V1-0
2CDC 501 036 D0201
Device connection
2CD
C0
72018F0007
Dimension drawing
1 Green LED
2 Mains supply
2CDC0
72016F0007
3 Label carrier
4 Bus connection terminal
(EIB / KNX output)
Switch on the mains voltage after the device has been correctly installed.
The ON-LED lights up after mains voltage was applied and the output voltage
is above 20 V DC.
The ON-LED flashes even if there is overload and if devices should
not work because of inappropriate bus topologies (very long bus lines).
The installer has to ensure that nominal current of 160 mA wont exceed
permanently.
Installation and
commissioning