4
SUNWORKER Warranty and Care

SUNWORKER...The SUNWORKER fabrics are coated with a solution dyed Plastisol® specially formulated to face sun radiance and climatic aggressions. In order not to spoil this finish,

  • Upload
    others

  • View
    1

  • Download
    0

Embed Size (px)

Citation preview

Page 1: SUNWORKER...The SUNWORKER fabrics are coated with a solution dyed Plastisol® specially formulated to face sun radiance and climatic aggressions. In order not to spoil this finish,

SUNWORKERWarranty and Care

Page 2: SUNWORKER...The SUNWORKER fabrics are coated with a solution dyed Plastisol® specially formulated to face sun radiance and climatic aggressions. In order not to spoil this finish,

CLEANING GUIDEDickson fabrics have all the necessary characteristics for inside and outside use and you should not encounter any specific problems if you respect the following recommendations :

• For awnings, the system should be positioned in such a way that there is perfect tension of the fabric with no rubbing. This tension will avoid the forming of pockets of water in the event of rain.

• In the rain, the blind or awning can be used but avoid retracting or rolling it up when damp and leaving if for a long period of time. If for different reasons, you had no choice, let it out within 48 hours if possible to allow it to dry.

• Respect the wind classes given by your blind or awning manufacturer.

Page 3: SUNWORKER...The SUNWORKER fabrics are coated with a solution dyed Plastisol® specially formulated to face sun radiance and climatic aggressions. In order not to spoil this finish,

STANDARD MAINTENANCE

STAIN REMOVAL

PROHIBITED CONTACTS

A visual checking is necessary every year to look out for the following :

• No cut or tear on the edges, inside the canvas, on the joints or on the seams.

• No vegetal or animal thick deposits

The fabric will have to be cleaned every two years following the instructions hereafter Unroll the

fabric completely.

• Remove the dust with a soft, non-metallic brush or with a vacuum cleaner.

• Wash the fabric using soapy water with a dilution of 10 % and at 20°C temperature.

• Rinse with clean water

• Repeat the operation if necessary

• Let it dry in the open air

• Roll up the fabric once dry

The SUNWORKER fabrics are coated with a solution dyed Plastisol® specially formulated to face sun radiance and climatic aggressions. In order not to spoil this finish, cleaning of the fabric must be done respecting the following recommendations.

Some stains may be difficult to remove ; in that case use a specific product like TEX’AKTIV clean from DICKSON CONSTANT , being careful to rinse it off well.

However, before taking any action, contact our technical [email protected]

Cleaning procedure Organic chemical products Inorganic chemical products

Abrasive powders Acetone, petrol, benzene Ammoniac – nitric acid

Abrasive paste Toluene - Trichloroethylene Bleach – acetic acid

Abrasive liquids Perchloroethilene Sulphuric acid

Abrasive sponge Kerosen – Turpentine oil Soda – Caustic soda

Pressurized beam Domestic fuel oil & others Chlorhydric acid

Page 4: SUNWORKER...The SUNWORKER fabrics are coated with a solution dyed Plastisol® specially formulated to face sun radiance and climatic aggressions. In order not to spoil this finish,

DICKSON CONSTANT SAS – 381 347 970 RCS Lille Métropolewww. dickson-constant.com

CONVENTIONAL WARRANTY

Conventional warranty is given by DICKSON CONSTANT to SUNWORKER fabric for 5 years from date of purchase of the blind and under the following conditions :

WE GUARANTEE :- Resistance to breaking at least equal to 100 daN/5cm in warp and 60 daN/5 cm in weft according to EN 13561 standards.- Fire retardant certification – Depending on the rangeM1 or M2 - NF 92503B1 : DIN 4102 / C1 : UNI 9176 / Classe 1 : UNE-EN 13773:2003) / Euroclass Bs2d0 (EN 13501-1)(fire retardant certificates available)- UV colour resistance : a minimum of 4/5, 4 class according to EN 13561 based on 1000 hours.- Replacement of the defective linear meters of fabrics excluding all other possible costs or any compensation.

The warranty covers exclusively the properly maintained fabrics under normal condition of use and environment.Any complaint must be sent within 10 days of the defect being noticed, accompanied by the purchase invoice, via registered mail with confirmation of receipt to the retailer where the product was initially bought.The fabric must be kept available to the experts of DICKSON CONSTANT or its insurance company. Replacement or reimbursement of the defective fabric does not extend the duration of the original warranty.

THIS WARRANTY DOES NOT COVER :- The parts of the awning other than the fabric manufactured by Dickson Constant - Imperfections such as mottling, block holes, bow effect within the tolerances of our data sheet in its new condition (cf additional technical report)- Defects from the ageing and normal wear of the cloth not exceeding the EN 13561 standards- The consequences of the conditions of installation, environment or use not corresponding to the usual conditions, the use of the profession, the standards prescribed by DICKSON CONSTANT or the destined use of the cloth.- The repair of damage or defects in the fabric resulting from accidents or negligence not to be charged to DICKSON CONSTANT or resulting from an unexpected event

EXPRESSLY EXCLUDED IN PARTICULAR IS ANY DETERIORATION DUE TO :- Faulty maintenance or the use of unsuitable products or instruments : no detergent, chemical product or solvent can be used , nor any scraper or other instrument that may damage the surface- Lightning or unusual climatic or environmental conditions- Atmospheric or phytosanitary pollution - Soiling caused by animals- Faulty assembly or handling by the user, the projection of various products, hanging objects on the fabric, falling objects, bumps, road accidents, vandalism, burns from cigarettes or other sources, fire.

This limited warranty shall under no circumstances pose an obstacle to the legal guarantees.