Upload
thirupathi-raja
View
214
Download
0
Embed Size (px)
Citation preview
8/18/2019 Spiral Stair Case
1/7
Staircase Radius
The staircase radius is the measurement from the centre of the staircase to the outer edge of the handrail. Weland manufactures spiral staircases with a radius of 600 to
1500 mm.
Rise
The rise should be chosen based on the given height between the landings. A suitable radius and the number ofsteps per revolution then determine the step rise.
The rise should be sized between 160 and 220 mm. The lower the rise ou choose! the deeper the step needs tobe. The normal rise is about 1"0 to 1#0 mm.
The formula for the rise is 2 $ h % W & 5#0'6(0.
Right or left turning staircase
Weland spiral staircases are manufactured with right or left turning. )ight turning means turning to the right from
the entrance point. *the centre tube to the right of upward travel+.
8/18/2019 Spiral Stair Case
2/7
Right turning
Left turning
Headroom
The headroom on the stairs must not be less than 2000 mm. The height is measured between two points locateddirectl below each other.
,easure from the top edge of the lower step-s nose to the lower edge of the level-s *step+ rear edge.
8/18/2019 Spiral Stair Case
3/7
Number of steps per revolution
The figures to the right are a guide when determining the number of steps perrevolution and the number rises. ount the number of rises between the landingsand compare the values for the obtained rise.
/ields mared *green+ in the table are the staircase dimensions that should be aimedfor during the planning stage.
Radiussteps/rev.
Going on walkingline*
Suitablerise
6001(6001560016
15"1("1"
200'220200'220200'220
"0015"0016"001""001#
1##1""16615"
200'220200'220200'220200'220
#0016#001"#001##0013#0020
216201321#21"
1#0'2101#0'210130'220130'220130'220
300163001"3001#3001330020
30021
2552(022"21520(
13(
1"5'2001"5'2001"5'2001#0'2101#0'210
1#0'210
8/18/2019 Spiral Stair Case
4/7
10001610001"
10001#100013100020
10002110002210002
23(2""
2622(#26
22(21(205
165'1#5165'1#5
165'1#51"5'2001"5'200
1#0'2101#0'2101#0'210
11001#1100131100201100211100221100211002(
23"2#126"25(2(22222
165'1#0165'1#0165'1301"0'2001"0'2001"0'2001"0'200
12001"12001#120013
1200201200211200221200212002(
5111(
23#2#(2"12532(3
155'130155'130155'130
155'130155'130160'2001"0'2001"0'200
1001#100131002010021
1002210021002(
66("01(
002#"2"5
155'1#0155'1#0155'1#0155'1#0
155'130155'130155'130
1(00201(00211(00221(002
1(002(1(0025
1(0026
61((2#1(
012#3
2"#
150'1#0150'1#0155'130155'130
155'130155'130
155'13015002215002
15002(15002515002615002"15002#
5"(1
2"1(022312#0
150'1#0150'1#0
150'1#0155'1#0155'1#0155'1#0155'1#0
& 4taircase dimensions that should be aimed for.
8/18/2019 Spiral Stair Case
5/7
The going is calculated to be on an imaginar waling line 250 mm from thecircumference.
8/18/2019 Spiral Stair Case
6/7
8/18/2019 Spiral Stair Case
7/7
http://www.weland.se/en-gb/spiraltrappa_industri_projektering/
http://www.arcat.com/details/divs/dd_div05.shtml
http://www.weland.se/en-gb/spiraltrappa_industri_projektering/http://www.arcat.com/details/divs/dd_div05.shtmlhttp://www.weland.se/en-gb/spiraltrappa_industri_projektering/http://www.arcat.com/details/divs/dd_div05.shtml