solo + Duolo seat

2

www.adventurebuggyco.com

Overview ...........................................................3

Warnings ...........................................................4

Adaptor bar attachment ............................6 - 7

Fitting & removing the solo & Duolo seat ....8

Folding & unfolding ..........................................8

Adjusting the backrest of the

solo & Duolo seat .............................................9

Using the safety bumper bar ........................10

Using the hood ................................................10

Using the 5 point harness / seat belt...........11

Rain cover and sun mesh use .......................12

General maintenance.....................................13

Warranty information ..............................13-14

contents

3

overview

Manufactured in New Zealand & China (fabric). Assembled in New Zealand.

solo + Duolo seatsolo seat Duolo seatDuolo seat

Seat areaBumper Bar

Hood

Adaptor BarAttachment

Seat adjustment buckles

Seat adjustment buckles

Flap windowsFlap window

the solo / Duolo seat includes:• solo (single seat) or Duolo (twin seat)• Rain & Sun covers as applicable • Adaptor bar

4

Important – Keep these InstructIons for future reference.

WarnIng – Never leave your child unattended.

WarnIng – Ensure that all locking devices are engaged before use.

WarnIng – To avoid serious injury ensure that your child is kept away when folding and unfolding this product.

WarnIng – Do not allow your child to play with this product.

WarnIng – Always use the full 5 point harness.

WarnIng – Check that the pram body and toddler seat accessories are correctly engaged before use.

WarnIng – This product is not suitable for running or skating.

WarnIng – Load your first children into the main Aspire Twin stroller seats.

WarnIng – After children are secured in the main Aspire stroller seats, place your third (and fourth) child into the solo (or Duolo) accessory seat(s).

WarnIng – DO NOT place a child in the solo or Duolo without a child in the Aspire Twin stroller seat.

WarnIng – DO NOT allow child to stand while in the solo or Duolo.

WarnIng – When dismounting child/children remove first from the solo/Duolo seat before releasing those in the Aspire Twin Pram/ Stroller

5

This product is suitable for children from 0 months (lay flat position) and up to 15kg’s per seat in the Duolo and 18kg in the solo.

Always engage the parking device when placing and removing the children in and out of the pram/stroller toddler seat accessory.

Any load attached to the handle and/or the backrest and/or on the sides of this pram/stroller or toddler seat accessory will affect the stability of the product.

Do not hang any bags etc. from the handle bar of this product.

Only use Adventure Buggy Co. solo and Duolo seat accessory products with this pram/stroller.

Use only accessories that have been approved by Adventure Buggy Co. for this product.

Use only replacement parts supplied by Adventure Buggy Co. for this product.

Do not over load the this product.

Remove and discard of all plastic wrapping, keep out of reach of children.

6

1. aDaptor Bar attachmentTo attach the Adaptor bar to the handle bar you must fi rst remove the handle bar from the buggy frame/chassis.

1) Apply the brake (1.a).

2) Unclip the top press-studs on the canopy and the top of buggy sling/seat (1.B).

3) Loosen the black tri-knobs at the base of the handle bar (1.c), pull the handle out to the fully extended position. Two silver spring button knibs will spring out into position on the buggy frame/chassis (1.D). Depress the spring buttons on the side of the frame/chassis and pull the handle bar away from the buggy frame/chassis to remove the handle bar completely (1.e).

1.A 1.B

1.C 1.D

1.E

7

Installing the adaptor bar onto the handle bar 1) With the Adaptor bar prongs facing upwards towards you, enter the handle bar into the tube openings of the Adaptor Bar (1.f).

2) Slide the handle through the Adaptor bar tube openings (note: you will have to depress the safety buttons on the handle bar to complete the process) (1.g).

3) With the Adaptor Bar now installed on to the handle bar, return the handle & adaptor bar combination to the buggy (1.h).

4) Ensure the safety buttons have clicked into the safety holes of the buggy frame (which is the fully extended position of the handle) (1.I).

5) Tighten the black tri-knobs at the base of the handle bar to tighten the handle bar into place (1.J).

Important: Slide the adaptor bar down the handle so that the adaptor bar tube brackets are flush with the TOP of the buggy chassis/frame.

1.F 1.G

1.G 1.H

1.I 1.J

8

2. fIttIng anD remoVIng the toDDLer seat 1) Position the hood of the Aspire buggy into the out stretched position.

2) Attach the toddler seat accessory to the adaptor bar by sliding the base of the toddler seat on to the adaptor bar prongs (2.a). Depressing the spring lock buttons on the adaptor bar (2.B) to allow the toddler seat to sit at the base of the adaptor bar prongs.

3) Check that the spring lock buttons on the adaptor bar have sprung back out into position once the toddler seat is attached (2.c).

4) To Remove the toddler seat from the adaptor bar for storage or folding, push in the spring lock buttons to remove the toddler seat off the adaptor bar.

5) The adaptor bar accessory does not need to be removed from the buggy for folding or storage.

3. foLDIng anD unfoLDIng Remove the toddler seat accessory as per the reverse of the steps above to enable the folding of the buggy.

Place the bumper bar of the toddler seat in the upright position to allow for the toddler seat to fold flat for storage (3.a).

Refer to Aspire buggy instructions for folding the buggy frame/chassis.

2.A

2.B 2.C

3.A

9

4. aDJustIng the soLo / DuoLo seat posItIon The Adventure Buggy Co. solo / Duolo seat back can be reclined to any point between upright and fully reclined position.

1) To adjust and recline the sling: Pull on the buckles at the rear of the baby sling (4.a), to permit the webbing straps to slide through and recline the seat.

2) To adjust and incline the sling. Pull evenly on both the webbing straps, and the seat will incline into the upright (4.B), toddler sitting position.

WarnIng: WARNING: children 0 – 6 months should be in the lowest lay flat position.

5. usIng the hooD The sun hood can be reclined or pulled out (5.a).

4.A

4.A

4.B 5.A

10

6. usIng the safetY Bumper Bar The padded Safety Bumper bar should only be positioned horizontally (6.a) so that the bar is ALWAYS sitting in front of the harnessed child.

The padded Safety Bumper Bar should be secured into position by using the wide buckled safety crotch strap , which fastens around the Safety Bumper Bar (6.B), between the child’s legs. The Duolo seat has two wide buckled safety crotch straps to secure (6.c).

WarnIng: Children should be kept away from moving parts when the responsible adult is handling or adjusting these parts, to avoid any injuries of cutting, compression or pinching.

6.B

6.C

6.A 6.B

X2

11

7. usIng the 5 poInt harness / seat BeLtEach seat is fi tted with a 5 point safety harness. Ensure that the harness is fi tted fi rmly at all times when the child is in the Toddler seat accessory.

1) To fasten the waist strap push both buckle ends into the crotch buckle.

2) Clip the shoulder straps to the center buckle (7.a).

3) Adjust the sliding buckles so that the harness straps are a fi rm fi t (7.B).

4) To release, press each side of the center buckle (7.c).

Remember to adjust the harness to suit each child and ensure it fi ts fi rmly. Make sure the belts are not twisted.

WarnIng: Use harness at all times.

7.A 7.B

7.C

12

8. raIn coVer anD sun mesh userain coverThe rain cover fi ts to the sun hood (8.a). The rain cover zips into place on the solo / Duolo seat accessory.

Important: The rain cover is shower proof only – we recommend using your Rain cover for only short intervals in heavy rain.

WarnIng: Do not leave rain cover on stroller in warm conditions. Check baby’s comfort frequently when using Rain cover.

sun meshThe sun mesh fi ts to the sun hood (8.B). The sun cover zips into place on the solo / Duolo seat accessory. 8.A

8.B

13

generaL maIntenance The Adventure Buggy Co. solo / Duolo seat accessory frame can be cleaned with mild soap and warm water, dry all parts thoroughly. Silicone spray can be used on moving parts of the frame if they become stiff over time.

Check the harnesses and fastening clips regularly for any wear and tear caused by general use over time.

To prevent fading of the fabrics be careful to not expose the fabrics of the pram/stroller to direct sunlight for prolonged periods. Fabrics can be hand washed with mild soap and warm water.

WarrantY InformatIon This product is covered by a 2 year warranty from the date of purchase. Please keep your receipt as proof of purchase. You will be required to supply your receipt for any warranty claims made.

We undertake to repair or replace any part, which is found to be defective within the warranty period.

Do not remove any labels containing model name/number from the pram/stroller frame, as these contain important information for warranty purposes.

This warranty excludes:

• General wear and tear of the product including wear and tear of fabrics.

• Airline damage

• Damage from neglectful use

• Corrosion or fabric damage, if stroller has been used or stored in extreme environmental conditions i.e. high humidity, salt spray.

• Deterioration due to lack of maintenance and cleaning as specified in Manufacturer’s instructions.

• Damage caused by dismantling or modifications.

14

If the product falls within the Warranty period:Before returning the product to us, please contact us as per the details below with the particulars. Go Bubba Go will arrange for assessment and appropriate action as quickly as possible.

Please make sure that the product is clean. Unacceptably dirty products will not be accepted or handled.

Warranty claims must be made to and will be attended by Adventure Buggy Co.’s distributor, Go Bubba Go at service@adventurebuggyco.com

This Warranty does not affect your Statutory rights.

repairs and replacement parts no longer under warranty. If the pram/stroller requires repair outside of the warranty period, please contact us with details of the problem and for further information and spare parts.

after saLes serVIce – WorLWIDe Contact us: service@adventurebuggyco.com

www.adventurebuggyco.com

adventure Buggy co. Incorporated

BVI Business Company N° 1869933

e: info@adventurebuggyco.com

Distributor

Boyd Global Enterprises Pty Ltd

Trading As Go Bubba Go

PO Box 194, St Kilda, VIC 3182

ph: 1800 462 822 (Australia Only)

e: info@gobubbago.com.au

adventurebuggyco.

www.adventurebuggyco.com