Solidworks Tutorials

Exercise 2: Moving Jaw For your second exercise you will be making the moving jaw component of your small vice. This is very similar to the component you made in your tutorial. Create it in the following steps:

1. Extrude Sketch Create the following sketch and extrude it by 40mm to create the bulk of the part.

Solidworks Tutorials

Exercise 2: Moving Jaw .

1.

2.

3.

2. Create Holes Next you need to use the Hole Wizard to create two holes. The holes are 15mm deep with 10mm deep threads. They are positioned as shown here:

3. Create Holes Create two similar holes (shown below) on the opposite side of your part. Again they are 15mm deep with 10mm deep threads. They are positioned as shown here:

4. Create Holes Finish your part by adding two more holes using the Hole Wizard. The holes should be positioned as shown here. They create holes through the part as shown and have threads along their whole length.

5.