Upload
vudan
View
228
Download
2
Embed Size (px)
Citation preview
SOLAR POWER
COMPONENTS
GUIDE FOR
INSTALLERS
Solar Energy New Zealand specialises in grid tied solar systems. Our solar systems come in
complete kits including the PV panels, inverter, roof framing system, DC cable and DC switch
gear.
Although we offer a complete range of fully certified solar power systems, we also provide a
complete range of components for the design and installation of solar systems for both domestic
and commercial use.
The attachment of PV modules to the roof is an important part of the installation to ensure
weather tight-ness and structural integrity. Astronergy have developed a range of fixings
specially for New Zealand’s standard roofing systems. This system uses an anodised aluminum
rail system and brackets for installation onto most common roof types, concrete tile, corrugated
iron, long run, with other types available on request.
Our roof framing systems have been tested and approved to the AS/NZ standards by CSM
Australia and documented certification can be downloaded from our website.
The roof framing has met the following AS/NZ standards:
• AS/NZ 1170.0 : 2011 Structural Designs Actions Part ); General Principles
• AS/NZ 1170.1 : 20102 A2-2009 Structural Design Actions Part 1: Permanent, imposed and other actions
• AS AS/NZ 1170.2 : 2011 – Structural Design Actions Part 2: Wind Actions
• AS1664.1 : 1997- Aluminium Structures part 1
We are proud to be the New Zealand distributors of Astronergy solar products.
Solar Panels
Inverters
PV cables
DC switch gear
Roof installation kitsSOLUTION
Solar1
Components Guide for InstallersPV modules
Inverters
Astronergy Polycrystalline PV module 250 watt output 38 volt DC open circuit1652 X 994 mm
Astronergy Monocrystalline PV module 250 watt output 38 volt DC open circuit1652 X 994 mm
Astronergy Monocrystalline PV moduleBlack series 250 watt output 38 volt DC open circuit1652 X 994 mm
Astronergy DC - AC inverters
1500 Watt - single Phase AC output
2000 Watt - single Phase AC output
3000 Watt - single Phase AC output
5000 Watt - single Phase AC output
10,000 Watt (10Kw)- 3 phase AC output
15,000 watt (15Kw) - 3 phase AC outputindent only
20,000 watt (20kW) - 3 phase AC outputindent only
CHSM6610M
CHSM6610MB(Black series)
CHSM6610P
INVER1500
INVER2000
INVER3000
INVER5000
INVER10000
INVER15000
INVER20000
Astronergy Solar PV modulesCHSM6610M
CHSM6610P
CHSM6610MB
Components Guide for Installers
DC protection
DC Switch Gear
Noark DC Isolator switch Din panel mount2 pole 25 A 600VNoark DC Isolator switch Din panel mount2 pole 25 A 750VNoark DC Isolator switch Din panel mount2 pole 32A 1000VNoark DC Isolator switch Din panel mount4 pole 32A 1000V
10 A DC 2 pole 500V MCB Din Mount16 A DC 2 pole 500V MCB Din Mount20A DC 2 pole 500 V MCB Din Mount
32A DC 2 pole 500 V MCB Din Mount
10A DC 4 pole 1000 V MCB Din Mount16A DC 4 pole 1000 V MCB Din Mount20A DC 4 pole 1000 V MCB Din Mount32A DC 4 pole 1000 V MCB Din Mount
Noark DC surge Arrestor 1 pole 500V DC
Noark DC surge Arrestor 3 pole 1000V DC
Noark DC Isolator 4 Pole 32 A IP67 surface mount.
Noark DC Isolator 4 Pole 32 A IP67 surface mount - Emergency type
noark
noark
DCS232600
DCS225750
DCS3231000
DCS4231000
DCMCB2P10ADCMCB2P16ADCMCB2P20A
DCMCB2P32A
DCMCB4P10ADCMCB4P16ADCMCB4P20ADCMCB4P32A
DCSAIP500
DCSA3P1000
DCSIP1000
DCSIP1000E
DC Isolators Panel/Din rail mount
DC IsolatorsIP67Surface mount
DC Isolators IP67Surface mountEmergency Type
DC 2 Pole Circuit Breakers
DC 4 pole Circuit Breakers
DC Surge protection
Components Guide for InstallersRoof Mounting Kits and Components
Corrugated roof hanger bolt M10 x 200
Solar mounting rail T-head bolt M8 x 25 S/S and flange nut
Solar mounting head bolt M8 x 25 S/S and flange nut
Solar panel stainless steel M5 mounting bolts
Stainless steel roof hooks for mounting solar aluminum rail on tile roofs
Seam clamp for long-run roofing
Rail nut (runs in rail slot)
Solar panel mounting rail joiner. Requires 2 per rail joint. (Top and bottom)
Solar module Aluminium mounting rail sold in 3 mtr lengths
Solar module mounting centre clamp
Solar module mounting end clamp
HANGBOLT
T-HEADBOLT
HEADBOLT
M5BLTPK
M5BLTPK
ROOFHOOKS
STANDSEAM
RAILNUT
JOINER
JOINER
RAILALUM
STANDSEAM
RAILNUT
HANGBOLT
CLAMPCTRCLAMPEND
HEADBOLTT-HEAD BOLT
FLANGENUT FLANGENUT
RAILALUM
CLAMPCTR
CLAMPEND
ROOFHOOKS
Components Guide for Installers
AC Components
DC Cable and Components
Connector
STFLEXCON
STFLEXGLN
NB1-63-16-1
Chint LBL001solar
VOLT 66SW132
VOLT 66SW363
CAB4MM
Solar cable connector MC4 compatible plug and socket compatible with Astronergy solar modules
Galvanised - Plastic coated flexible conduit. Sold per metre
20 mm flexible conduit glands (Galv) with earth tab
CHINT 16 A 250 V AC MCB
Solar 32 A 250V AC isolator switch(mechanism is engraved SOLAR)
IP66 32A 250V AC 1 Pole isolator switchSurface mount
IP66 63A 500V AC 3 Pole isolator switchSurface mount
Solar cable 4mm2 DC single coreSold per metre or in 100m rolls
Components Guide for Installers
Sundry Components
TECHNICAL
Montioring Systems
Astonergy Solar Vision local monitoring de-vice.Display and Wireless interface
Solar installation Label KitCovers the labeling requirements as re-quired in AS/NZS 5033:2012
SYSVISION
LABKIT
Solarvision
16
52
mm
994mm
MODULE DIMENSIONS MODULE INSTALLATION PARTS TILE ROOF BRACKETS
Rafter
Galv woodscrews
Hanger bracket
Note:Installers should be fully conversant with the requirements of AS/NZS 5033:2012 and amendments before undertaking the Installation.
P: 0508 NZSOLAR 0508 697 6527E: [email protected]: www.solarenergynz.co.nz
The worlds second largest manufacturer of Solar equipment
Top 2% of Solar ManufacturesVertically integratedInvests heavily in R&D
Advanced robotic processManufacturing solar modules for more than 5 years