Upload
others
View
6
Download
0
Embed Size (px)
Citation preview
Instructions1. Using the pa�ern, cut the snake head out of cra� foam.2. Fold the head in half and staple on both sides.3. Glue the eyes on the snake’s head. Then cut a hole where the “X” is. Slide the party blower through the hole.4. Cut at least 20 stripes of cra� foam using the tail strips pa�ern.5. Thread one strip through the back of the snake’s head and staple to form a loop. Continue to thread a strip through the last loop, making a chain tail.
Snake Head
Tail StripsCut at least 20
Snake Puppet
© 2011 RANGER RICK JR. and its logo are trademarks of the NATIONAL WILDLIFE FEDERATION. All rights reserved.
N�W�F®