C

D

E

A

G

B

H

I

Assembly instructions HL6500

SmartphoneHolder XL

x1 — Phone Holder

x1 — Bungee

x1 — Handlebar ClampBolt

x2 — Rubber Shim

x1 — Thumb Screw

x1 — Stem Mount

x1 — Short Bolt

x1 — Dry Bag

x4 — Phone Bumpers

Parts

A

B

C

D

E

F

G

HH

I

Tool RequiredPhillips HeadScrewdriver

WARNINGUsing phone device while riding can cause accidents resulting in serious injury.Important: Nuts and bolts can loosen over time, resulting in serious danger should the item fall o� while in motion.Check frequently to ensure all bolts are properly tightened. Ensure the device �ts snugly in the holder before riding.Not for o�-road use.

STEM MOUNT OPTIONHANDLEBAR CLIP OPTION

F

STEM BOLT

1

1

2

2

1

1

2

2

Delta Cycle Corporation 36 York Avenue, Randolph, MA 02368 USA / 800-474-6615 / www.designbydelta.com

Need help?Email us at service@designbydelta.com& we’ll help solve your issue.

Assembly videoVisit designbydelta.com/downloads

Using the Handlebar Clamp

Using the Stem Mount

IMPORTANTSAFETY NOTEDo not attach clampto any tapered sectionof your handlebar.

IMPORTANTSAFETY NOTE

Connect holder to handlebar clampusing short bolt and adjust angle beforefull tightening.

Connect handlebar clamp to barusing rubber shims as needed. Use thumb screw; tighten tosecure the handlebar clamp.

Remove existing stem cap from bicycle.Use existing stem bolt to install Smartphone Holder stem mount on to your bicycle stem.

Connect holder to stem mountusing short bolt and adjust anglebefore full tightening.

Never loosen thestem clamp bolts.