Upload
intermountainwater
View
221
Download
0
Embed Size (px)
Citation preview
7/28/2019 Simple Clean Installation and Startup Procedure
1/1
Simple Clean
Installation & Startup
Procedure
Clear the
installation area &
sweep the floor
where the system
will be installed
Existing Softener Install Simple Clean Upstream of softener
Is household
pressure 50-75psi
static
This is an unsafe condition
DO NOT CONTINUE INSTALLATION
CALL TECH-SUPPORT
1-800-454-3429
Is there adequate
thermal expansion
protection ?
YES
NO
NO
Connect to household plumbing according to code.
Install system on the DOWNFLOW INLET port
Install Leak
Controller
& Drip Tray
CALL TECH-SUPPORT
1-800-454-3429
Bypass Simple
Clean and all
downstream
treatment
equipment
Run bathtub cold
to purge debris &
flux from piping.
Leave tub running
(5 minutes)
Bring system
online slowly and
check for leaks,
then return to tub
& observe water
Run water until
clear, then turn off
tub
(10 Minutes)
IS THERE GRANULAR
CARBON IN THE
WATER ?
YES
NO
INSTALLATION &
STARTUP IS COMPLETE
Register Warranty1-800-454-3429
Customer NameCustomer email
Customer Address
Customer Phone
System Serial No.
Version 1.0
Bring downstream
equipment online
slowly, and check
for leaks