SILLITES RR9 INSTALLATION INSTRUCTIONS

Before: After:

THE SILLITES RR9 IS DESIGNED FOR EASY RETRO-FITTING INTO EXISTING WINDOWS

WITH 2” OR WIDER WINDOWSILLS

RR9 comes with a 9’ whip of 14/2 Romex attached to it.

1”

1-7/8”

1-1/2”

DRILL A 1-1/2” DIAMETER HOLE AT LEAST 1” FROM THE SASH

Drill second hole in rear for wire to enter the wall cavity. 1/2” Minimum

depth of large hole.

“FISH” THE WIRE FROM THE RR9 THROUGH THE WALL TO THE NEAREST OUTLET

IF THE OUTLET CANNOT BE ACCESSED DIRECTLY, POP OFF THE BASEBOARD

TRIM, RUN THE WIRE DOWN AND BEHIND IT TO THE OUTLET.

SECURE THE RR9 WITH THE MOUNTING SCREWS

SLIDE BEAUTY RING SHIPPED WITH THE SL7 CANDLE OVER THE RR9

A paintable cover cap is also included with the RR9.

The “beauty ring” matches the finish of the candle to extend the base over the top of the RR9.

Plug In The SL7 CandleAn accessory photo-cell (Cat # PCW) can be added to turn the light off during the day. It screws in between the socket & the bulb and will also work in coach lights with lamps up to 75 watts.