Sikabond NV Msds

IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OFTHE COMPANY/UNDERTAKING

Product name or Trade name :

1.

Identification of the substance/preparation

Company/undertaking identification

SikaBond NV

-Emergency telephone number

P.T. Sika IndonesiaJL. Raya Cibinong - Bekasi km 20Limusnunggal Cileungsi Bogor, 16820Indonesia

Manufacturer/Distributor

+62 21 823 0025Telephone no.Fax no. +62 21 823 0026e-mail address of personresponsible for this SDS

-

Use of the substance/preparation Chemical product for construction and industry

:

:::

:

:

Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II

Safety Data Sheet

HAZARDS IDENTIFICATION

Xi, R36:Human health hazards Irritating to eyes.

See section 11 for more detailed information on health effects and symptoms.

2.

:ClassificationThe product is not classified as dangerous according to Directive 1999/45/EC and its amendments.

COMPOSITION/INFORMATION ON INGREDIENTS3.Chemical family/Characteristics

Aqueous dispersion of polyvinylacetate:

Ingredient name CAS number % EC number Classification

vinyl acetate 108-05-4 25-35 203-545-4 F; R11 [2]See section 16 for the full text of the R-phrases declared above

Occupational exposure limits, if available, are listed in section 8.

[1] Substance classified with a health or environmental hazard[2] Substance with a workplace exposure limit

Do not induce vomiting unless directed to do so by medical personnel. Maintain anopen airway. Seek immediate medical attention.

Skin contact

Immediately flush eyes with plenty of water, occasionally lifting the upper and lowereyelids. Check for and remove any contact lenses. Continue to rinse for at least 10minutes. Get medical attention.

Flush contaminated skin with plenty of water. Remove contaminated clothing andshoes. Obtain medical attention if symptoms occur.

4.First-aid measures

Obtain medical attention if symptoms occur.IngestionInhalation

Eye contact

:

:

:

:

FIRST AID MEASURES

Date of issue : 1/5603092MSDS no. :16.09.2009.

SikaBond NV 16.09.2009 2/5

4. FIRST AID MEASURESNotes to physician No specific treatment. Treat symptomatically. Contact poison treatment specialist

immediately if large quantities have been ingested or inhaled.:

See section 11 for more detailed information on health effects and symptoms.

FIRE-FIGHTING MEASURES

Hazardous combustionproducts

Special exposure hazardsDecomposition products may include the following materials:carbon dioxidecarbon monoxide

In a fire or if heated, a pressure increase will occur and the container may burst.

Fire-fighters should wear appropriate protective equipment and self-containedbreathing apparatus (SCBA) with a full face-piece operated in positive pressuremode.

Special protectiveequipment for fire-fighters

Use an extinguishing agent suitable for the surrounding fire.Extinguishing media

::

:

None known.Suitable :Not suitable :

5.

Environmental precautions

Personal precautions

6. ACCIDENTAL RELEASE MEASURES

:

: Keep unnecessary and unprotected personnel from entering. Do not touch or walkthrough spilt material. Put on appropriate personal protective equipment (see section8).Avoid dispersal of spilt material and runoff and contact with soil, waterways, drainsand sewers. Inform the relevant authorities if the product has caused environmentalpollution (sewers, waterways, soil or air).Stop leak if without risk. Move containers from spill area. Prevent entry into sewers,water courses, basements or confined areas. Wash spillages into an effluenttreatment plant or proceed as follows. Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earthand place in container for disposal according to local regulations (see section 13).

Large spill :

Stop leak if without risk. Move containers from spill area. Absorb with an inertmaterial and place in an appropriate waste disposal container.

Small spill :

Handling

HANDLING AND STORAGE

Storage

7.Put on appropriate personal protective equipment (see section 8). Eating, drinkingand smoking should be prohibited in areas where this material is handled, stored andprocessed. Workers should wash hands and face before eating, drinking andsmoking. Avoid contact with eyes, skin and clothing. Keep in the original container oran approved alternative made from a compatible material, kept tightly closed whennot in use.

Packaging materials

Store in accordance with local regulations. Store in original container protected fromdirect sunlight in a dry, cool and well-ventilated area, away from incompatiblematerials (see section 10) and food and drink. Keep container tightly closed andsealed until ready for use. Containers that have been opened must be carefullyresealed and kept upright to prevent leakage. Do not store in unlabelled containers.Use appropriate containment to avoid environmental contamination.

:

:

Recommended : Use original container.


SikaBond NV 16.09.2009 3/5

Ingredient name Occupational exposure limits

Recommended monitoringprocedures

vinyl acetate ACGIH TLV (United States, 1/2007).STEL: 53 mg/m 15 minute(s).

STEL: 15 ppm 15 minute(s). TWA: 35 mg/m 8 hour(s). TWA: 10 ppm 8 hour(s).

Exposure limit values

If this product contains ingredients with exposure limits, personal, workplaceatmosphere or biological monitoring may be required to determine the effectivenessof the ventilation or other control measures and/or the necessity to use respiratoryprotective equipment. Reference should be made to European Standard EN 689 formethods for the assessment of exposure by inhalation to chemical agents andnational guidance documents for methods for the determination of hazardoussubstances.

8. EXPOSURE CONTROLS/PERSONAL PROTECTION

Respirator selection must be based on known or anticipated exposure levels, thehazards of the product and the safe working limits of the selected respirator.organic vapour filter (Type A)A1: < 1000 ppm; A2: < 5000 ppm; A3: < 10000 ppm

Respiratory protection

:

Occupational exposurecontrols

: Good general ventilation should be sufficient to control worker exposure to airbornecontaminants. If this product contains ingredients with exposure limits, use processenclosures, local exhaust ventilation or other engineering controls to keep workerexposure below any recommended or statutory limits.Wash hands, forearms and face thoroughly after handling chemical products, beforeeating, smoking and using the lavatory and at the end of the working period.Appropriate techniques should be used to remove potentially contaminated clothing.Wash contaminated clothing before reusing.

Exposure controls

Hygiene measures :

Hand protection Chemical-resistant, impervious gloves complying with an approved standard shouldbe worn at all times when handling chemical products if a risk assessment indicatesthis is necessary. Recommended: Butyl rubber/nitrile rubber gloves.Safety eyewear complying with an approved standard should be used when a riskassessment indicates this is necessary to avoid exposure to liquid splashes, mists,gases or dusts.

Eye protection

:

Skin protection Personal protective equipment for the body should be selected based on the taskbeing performed and the risks involved and should be approved by a specialist beforehandling this product. Recommended: Use barrier skin cream.

:

Environmental exposurecontrols

: Emissions from ventilation or work process equipment should be checked to ensurethey comply with the requirements of environmental protection legislation. In somecases, fume scrubbers, filters or engineering modifications to the process equipmentwill be necessary to reduce emissions to acceptable levels.

PHYSICAL AND CHEMICAL PROPERTIES

Form Paste.

Characteristic.OdourWhite.Colour

9.

:

::

General informationAppearance

Important health, safety and environmental informationDensity : 1.04 - 1.05 g/cm3 [20C (68F)]


SikaBond NV 16.09.2009 4/5

Hazardous decompositionproducts

Conditions to avoid No specific data.

STABILITY AND REACTIVITY

Under normal conditions of storage and use, hazardous decomposition productsshould not be produced.

The product is stable.Stability

10.

No specific data.

::

:Materials to avoid :

TOXICOLOGICAL INFORMATION11.Potential acute health effects

Inhalation : May cause irritation.Can cause gastrointestinal disturbances.:Ingestion

Skin contact : May cause skin irritation.May cause eye irritation.:Eye contactNo known significant effects or critical hazards.Chronic effects :

ECOLOGICAL INFORMATION12.Environmental effects : Avoid contact of spilt material and runoff with soil and surface waterways. Do not

empty into drains; dispose of this material and its container in a safe way.

DISPOSAL CONSIDERATIONS13.The generation of waste should be avoided or minimised wherever possible. Emptycontainers or liners may retain some product residues. This material and its containermust be disposed of in a safe way. Dispose of surplus and non-recyclable productsvia a licensed waste disposal contractor. Disposal of this product, solutions and anyby-products should at all times comply with the requirements of environmentalprotection and waste disposal legislation and any regional local authorityrequirements. Avoid dispersal of spilt material and runoff and contact with soil,waterways, drains and sewers.

:Methods of disposal

Completely emptied packagings may be given for recycling. Empty packaging maystill contain hazardous residues. Empty packaging should be removed by a licensedwaste contractor.

Packaging :

14.International transport regulations

TRANSPORT INFORMATION

ADR

IMDG

No.Marine pollutantIATA

:

Proper shipping name :Not regulated.

Not regulated.

Not regulated.


SikaBond NV 16.09.2009 5/5

REGULATORY INFORMATION15.

R22- Harmful if swallowed. R36/38- Irritating to eyes and skin.

Hazard symbol or symbols

Risk phrases

EU regulations

:

:Irritant

Classification and labeling have been determined according to EU Directives 67/548/EEC and 1999/45/EC(including amendments) and take into account the intended product use.

Xi

Remark :VOC content (EU) : VOC (w/w): 0%

Regulatory information : Classification according to PP N. 74 Th. 2001The product is classified as Bersifat Iritasi (Irritant) Substance

OTHER INFORMATION16.:Full text of classifications

referred to in sections 2 and3

R11- Highly flammable.

F - Highly flammable:Full text of classificationsreferred to in sections 2 and3

16.09.2009.History

Date of printingDate of issue 16.09.2009.

Notice to reader

Date of previous issue 08.09.2008.

:::

Indicates information that has changed from previously issued version.

The information contained in this Safety Data Sheet corresponds to our level of knowledge at the time ofpublication. All warranties are excluded. Our most current General Sales Conditions shall apply. Please consultthe Technical Data Sheet prior to any use and processing.


Documents

Sikabond NV Msds