Upload
others
View
6
Download
0
Embed Size (px)
Citation preview
Hints• Cow Catcher
• Axle Peg
Cow Catcher
• These are NOT step-by-step directions. The goal is to provide guidelines and suggestions.
Cow Catcher
Make sure you create a sketch on the XZ PLANE
Cow Catcher
Dimensions for one side
Cow Catcher
Create 2D Sketch, then hold and drag up, then type 0.75
Cow Catcher
Cow Catcher
Use Project Geometry
Dimensions for other side
Cow Catcher
• Loft
• Shell (0.1)
• Create 2D Sketch (then use offset tool), dimension .1 from top, then extrude CUT 0.05
• Make pegs on back
Cow Catcher
Make sure you have the correct dimensions, then extrude .125 and chamfer
Axle Peg
Make sure you create a sketch on the XZ PLANE
Axle Peg
• Sketch half of cylindrical profile and revolve.
• 0.25/2, then 1, then unknown distance, then .031, create arc, then close shape
• Add dimensions
• .422/2, then arc=.236,
Axle Peg
Axle Peg
Make center mark coincident with (vertical) y-axis.
Axle Peg
• Finish sketch, revolve
• Make offset sketch plane: Create 2D Sketch, hold and drag -0.125
Axle Peg
Slice Graphics
Axle Peg
• Project Geometry of circle, finish sketch, extrude CUT (distance all)
Axle Peg
• New Sketch, use polygon tool to draw hexagon (6 sides) onto flat surface
Axle Peg
• Dimension 5/32, Extrude cut .111
• Chamfer bottom edge
• Use Thread tool with ¼ in offset