1. Conduct experiment on Lathe. (All dimensions are in mm)

2. Conduct experiment on Lathe. Single start thread cutting (All dimensions are in mm)

3. Prepare specimens and weld as shown in figure.

4. Fabricate a funnel as given in the diagram (Thickness is 1mm and all dimensions are in mm )

5. Fabricate a tray as shown below.(Thickness 1mm and all dimensions are in mm)

6. (i) Explain taper turning by compound rest (20) (ii) Conduct experiment on Lathe (80)

7. (i) Explain Tailstock set over method (20) (ii)Conduct experiment of Internal boring in Lathe (80)

6. (i) Explain taper turning by compound rest (20) (ii) Conduct experiment on Lathe (80)

1. Conduct experiment on Lathe. (All dimensions are in mm)

1. Conduct experiment on Lathe. (All dimensions are in mm)

3. Prepare specimens and weld as shown in figure.

5. Fabricate a tray as shown below.(Thickness 1mm and all dimensions are in mm)

5. Fabricate a tray as shown below.(Thickness 1mm and all dimensions are in mm)

3. Prepare specimens and weld as shown in figure.

9. Make the T-joint from the given 6mm Thick 2Nos MS plate by suitably setting the amperage and selecting the electrode

7. Make the Butt joint from the given 6mm Thick 2Nos MS plate by suitably setting the amperage and selecting the electrode