1. Turn the MS rod of Diameter 25mm as shown in the sketch, (All dimensions are in mm)

2. Turn the MS rod of Diameter 20mm as shown in the sketch, (All dimensions are in mm)

3. Turn the MS rod of Diameter 40mm and make single start thread as shown in the sketch, (All dimensions are in mm)

4. Turn the MS rod of Diameter 40mm and do the boring operation as shown in the sketch, (All dimensions are in mm)

5. Make the funnel from the given 1.5 thick MS sheet as shown in the sketch, (All dimensions are in mm)

6. Make the Rectangular tray from the given 1.5 thick MS sheet as shown in the sketch. (All dimensions are in mm)

7. Make the Butt joint from the given 6mm Thick 2Nos MS plate by suitably setting the amperage and selecting the electrode

8. Make the Lap joint from the given 6mm Thick 2Nos MS plate by suitably setting the amperage and selecting the electrode

9. Make the T-joint from the given 6mm Thick 2Nos MS plate by suitably setting the amperage and selecting the electrode

1. Turn the MS rod of Diameter 25mm as shown in the sketch, (All dimensions are in mm)

2. Turn the MS rod of Diameter 20mm as shown in the sketch, (All dimensions are in mm)

6. Make the Rectangular tray from the given 1.5 thick MS sheet as shown in the sketch. (All dimensions are in mm)

7. Make the Butt joint from the given 6mm Thick 2Nos MS plate by suitably setting the amperage and selecting the electrode

8. Make the Lap joint from the given 6mm Thick 2Nos MS plate by suitably setting the amperage and selecting the electrode

2. Turn the MS rod of Diameter 20mm as shown in the sketch, (All dimensions are in mm)

1. Turn the MS rod of Diameter 25mm as shown in the sketch, (All dimensions are in mm)

9. Make the T-joint from the given 6mm Thick 2Nos MS plate by suitably setting the amperage and selecting the electrode