Upload
others
View
26
Download
0
Embed Size (px)
Citation preview
SECTIONAL VIEWS
Dr. Aylin YENİLMEZ-GÜRKÖK
Dr. Aylin Gurkok - Florida International University - College of Engineering - Department of Mechanical and Materials Engineering - Miami
1.The position of the cutting plane is indicated by the center line A-A,
2. The part of the object behind the arrows is removed in the sectional view. The
sectional view can either be an elevation or plan.
3. Cut surfaces produced by cutting planes are called sections and they are hatched
with thin continuous lines, equally spaced and usually at 45º as shown.
SECTIONAL VIEWS Dr. Aylin Gurkok - Florida International University - College of Engineering - Department of Mechanical and Materials Engineering - Miami
Types of Sectional Views
Half Sections
Dr. Aylin Gurkok - Florida International University - College of Engineering - Department of Mechanical and Materials Engineering - Miami
Types of Sectional Views
Local or Broken-out Sections
Dr. Aylin Gurkok - Florida International University - College of Engineering - Department of Mechanical and Materials Engineering - Miami
Types of Sectional Views
Part or Scrub Sections
Dr. Aylin Gurkok - Florida International University - College of Engineering - Department of Mechanical and Materials Engineering - Miami
Types of Sectional Views
Revolved Sections
Dr. Aylin Gurkok - Florida International University - College of Engineering - Department of Mechanical and Materials Engineering - Miami
Types of Sectional Views Removed Sections
Dr. Aylin Gurkok - Florida International University - College of Engineering - Department of Mechanical and Materials Engineering - Miami
Types of Sectional Views Off-set Section
Dr. Aylin Gurkok - Florida International University - College of Engineering - Department of Mechanical and Materials Engineering - Miami
Types of Sectional Views
Aligned Section
Dr. Aylin Gurkok - Florida International University - College of Engineering - Department of Mechanical and Materials Engineering - Miami
Omission of Hatch Lines
Webs or Ribs and Spokes and Ribs
Dr. Aylin Gurkok - Florida International University - College of Engineering - Department of Mechanical and Materials Engineering - Miami
Details not Sectioned on Assemblies
Spokes aligned and not sectioned
Dr. Aylin Gurkok - Florida International University - College of Engineering - Department of Mechanical and Materials Engineering - Miami
Details not
Sectioned on
Assemblies
Dr. Aylin Gurkok - Florida International University - College of Engineering - Department of Mechanical and Materials Engineering - Miami
Dr. Aylin Gurkok - Florida International University - College of Engineering - Department of Mechanical and Materials Engineering - Miami