Upload
others
View
3
Download
0
Embed Size (px)
Citation preview
THIS BLOCK OF COLOR BLEEDS OFF THE PAGE 1/8” ON ALL SIDES.SAME WOULD GO FOR IMAGES OR PHOTOS THAT ARE PLACED AT THE EDGE
OF THE PAGE.
San MarinoEnamel Glass & Coordinating Ceramic Wall Tile
D E S I G N S
RoseannSan Marino by
Shown Here:Matte Chevron Mosaic
in Fawn
Gloss Herringbone Mosaic
Smoke
Slate
Sapphire
Sky
Sage
Seafoam
Pearl
Smeralda
Frost
Colonial Blue
Fawn
Cloud
Dove
Blue Grass
Matte Bubble Mosaic
Matte Field Tile w/ Polished Dot Basketweave Mosaic
Frost and Black Frost and Sapphire
Pearl and Fawn Frost and Sky Frost and Cloud
Mix #3Pearl, Frost, and Fawn
Mix #1Smeralda, Frost, and
Seafoam
Mix #2Dove, Frost, and Cloud
Shown Here:Gloss Herringbone Mosaic
in Cloud
Matte Chevron Mosaic
Smoke
Slate
Sapphire
Sky
Sage
Seafoam
Pearl
Smeralda
Frost
Colonial Blue
Fawn
Cloud
Dove
Blue Grass
Matte Cube Mosaic
Cube #6Sage, Frost, and Colonial Blue
Cube #5Black, Frost, and Charcoal
Cube #4Slate, Frost, and Blue Grass
Cube #3Dove, Smoke, and Cloud
Cube #2Smeralda, Frost, and Seafoam
Cube #1Pearl, Frost, and Fawn
Shown Here:Gloss Herringbone Mosaic
in Cloud
Matte Hexagon Mosaic
Smoke
Slate
Sapphire
Sky
Sage
Seafoam
Pearl
Smeralda
Frost
Colonial Blue
Fawn
Cloud
Dove
Blue Grass
2”x8” Coordinated Gloss Wall Tile
Sapphire
Slate
Smoke
Cloud
Fawn
Pearl
Frost
Snow
Colonial Blue
Smeralda
Blue Grass
Sky
Sage
Seafoam
Dove
Trim Pieces
2”x8.5” Molding in Gloss.75”x8.5” Pencil in Gloss .625”x8.5” Quartino in Gloss
* Trim Pieces Available in All Colors
Shown Here in Shower:Gloss Herringbone Mosaic in Cloud
Matte Bubble Mosaic in Mix 2Shown Here Outside Shower:
Basketweave Mosaic in Frost and Black
Installation Instructions for Enamel Glass
Installation Instructions:
1. Setting - Any setting product that is recommended for use with glass mosaics can be used for the enamel glass.
2. Sealing - The matte finish glass/enamel tile requires the use of a sealer prior to grouting so that the grout color does not get into the pores (similar to stone). This will reduce the risk of grout pigments entering the pores and changing the color of the product. The gloss finish does not require sealing prior to grouting.
3. Grouting - Allow adhesive to cure for 24 hours prior to grouting.
Matte finish - Take caution with the type of grout used because if the sealer gets into the joint, the grout can become discolored. We have tested and recommend Tec Power Grout. This proved to be the best grout for color consistency and clean-ability.
Gloss finish - any non-sanded grout may be used.
Uses:
Gloss - 1. Any wall application, interior and exterior.2. Light duty floors.3. Can be used in submerged wet areas, mud showers, and steam showers.
Matte - 1. Any wall application, interior and exterior.2. Light Commercial Floors.3. Can be used in submerged wet areas, mud showers, and steam showers.
Light colors - 1. Light colors can be used for floor applications, however they tend to show dirt quickly. They can be easily cleaned. This is not recommended in commercial areas.
Maintenance: 1. Use a neutral detergent for cleaning.2. Rinse with clean water and dry with a clean cloth.3. Do not use abrasive brushes. **2”x8” Wall tile for wall installation only.
**All products should be inspected prior to installation. Claims for defective product will not be accepted after installation.
Features Test Method Requirements Results
Facial Defects ANSI A 137.2 7.1 The samples shall be within tolerance for facial defects
Complied
Structural Defects ANSI A 137.2 7.1 The samples shall be within tolerance for structural defects
Complied
Thickness ASTM C499 ≤0.76mm .43mm
Nominal Size ASTM C499 ±10.00% -2.54%~-0.04%
Caliber Range ASTM C499 ±5.00% -1.10%~+1.14%
Static Coefficient of Friction ASTM C1028 As Reported Dry: 0.83Wet: 0.61
Dynamic Coefficient of Friction
Refer to ASTM C1028 As Reported Dry: 0.60Wet: 0.55
Water Absorption ASTM C373 ≤0.5% 0.03%~0.05%
Acetic Acid, 3% and 10% (v/v)
ASTM C650 As Reported Not affected
Ammonium Chloride, 100g/L ASTM C650 As Reported Not affected
Citric Acid Solution, 30g/L and 100g/L
ASTM C650 As Reported Not affected
Lactic Acid, 5% (v/v) ASTM C650 As Reported Not affected
Phosphoric Acid 10% (v/v) ASTM C650 As Reported Not affected
Sulfamic Acid, 30g/L and 100g/L
ASTM C650 As Reported Not affected
Sodium Hypochlorite Solution, 20mg/L
ASTM C650 As Reported Not affected
Hydrochloric Acid Solution, 3% and 18% (v/v)
ASTM C650 As Reported Not affected
Potassium Hydroxide, 30g/L and 100g/L
ASTM C650 As Reported Not affected
Chemical Resistance Class ANSI A 137.2 5.2.3.5 As Reported Class A
Waterproof ink black ASTM C1378 As Reported Not affected
Washable ink ASTM C1378 As Reported Not affected
Potassium permanganate solution, 1%
ASTM C1378 As Reported Not affected
Methylene blue solution, 1% ASTM C1378 As Reported Not affected
Stain Resistance Class ANSI A 137.2 52.3.6 As Reported Class A
Linear Thermal Expansion ASTM C372 As Reported N/A
Moisture Expansion ASTM C370 As Reported N/A
Thermal Shock Resistance ANSI A 137.2 7.9 Pass Fully Resistant
Frost Resistance ASTM C1026 Pass Fully Resistant
Glass Tile
Product info:l Glass Tilel Gloss and Matte Finishl Frost Resistance = Yl Contact your sales representative for more information www.galleriastone.com
THIS BLOCK OF COLOR BLEEDS OFF THE PAGE 1/8” ON ALL SIDES.SAME WOULD GO FOR IMAGES OR PHOTOS THAT ARE PLACED AT THE EDGE
OF THE PAGE.
Shown Here:Gloss Herringbone Mosaic
in Sapphire