8/17/2019 Safe Work Procedure http://slidepdf.com/reader/full/safe-work-procedure 1/1 Alberta Construction Safety Association SAFE WORK PRACTICE TITLE Cold Cutting Plant Piping GENERAL Protecting workers from injuries associated with cold cutting process APPLICATION When required to cold cut a line, necessary steps must be taken to minimize risk to personnel and enironment! PROTECTIVE MECHANISMS Safe work procedure "round disturbance process #nironmental legislation PP# #$P %#mergency response plan & 'S(S W)'*S SELECTION AND USE As per safe work procedure #nironmental legislation SUPERVISOR RESPONSIBILITY Superisors are responsible to facilitate and+or proide proper instruction to their workers on protection requirements and training )azard assessment WORKER RESPONSIBILITY ! #nsure barricades and warning signs in place! -! #nsure line is secured and properly supported! .! #nsure proper body position for cutting! /! #nsure proper cold cutter is utilized! 0! Contain product seepage! 1! #nsure pipe segment is remoed from area! 2! #nsure to remoe sharp edges as soon as pipe segment is taken out! 3! Protector caps or plastic thread protectors to be utilized! 4! #nsure adequate method for plugging line based on site specific work process and product! 5 6he information presented in this publication is intended for general use and may not apply to eery circumstance! *t is not a definitie guide to goernment regulations and does not reliee persons using this publication from their responsibilities under applicable legislation! 6he Alberta Construction Safety Association does not guarantee the accuracy of, nor assume liability for, the information presented here! *ndiidual counselling and adice are aailable from the Association! SWP777048+

Safe Work Procedure

Download PDF Report

Upload
sameer327
View
219
Download
0

Embed Size (px)

Citation preview

8/17/2019 Safe Work Procedure

http://slidepdf.com/reader/full/safe-work-procedure 1/1

Alberta Construction Safety Association

SAFE WORK PRACTICE

TITLE Cold Cutting Plant Piping

GENERAL Protecting workers from injuries associated with cold cutting process

APPLICATION When required to cold cut a line, necessary steps must be taken tominimize risk to personnel and enironment!

PROTECTIVEMECHANISMS

Safe work procedure"round disturbance process#nironmental legislationPP##$P %#mergency response plan &'S(SW)'*S

SELECTION

AND USE

As per safe work procedure#nironmental legislation

SUPERVISOR

RESPONSIBILITY

Superisors are responsible to facilitate and+or proide properinstruction to their workers on protection requirements and training

)azard assessmentWORKER

RESPONSIBILITY

! #nsure barricades and warning signs in place!-! #nsure line is secured and properly supported!.! #nsure proper body position for cutting!/! #nsure proper cold cutter is utilized!0! Contain product seepage!1! #nsure pipe segment is remoed from area!2! #nsure to remoe sharp edges as soon as pipe segment is taken

out!3! Protector caps or plastic thread protectors to be utilized!4! #nsure adequate method for plugging line based on site specific

work process and product!5 6he information presented in this publication is intended for general use and may not apply to eery circumstance! *t isnot a definitie guide to goernment regulations and does not reliee persons using this publication from theirresponsibilities under applicable legislation! 6he Alberta Construction Safety Association does not guarantee the accuracyof, nor assume liability for, the information presented here! *ndiidual counselling and adice are aailable from the

Association!

SWP777048+