7/24/2019 Ruckus_SNMP.pdf

1/2

Configuring SNMP SupportZoneDirector provides support for Simple Network Management Protocol (SNMP v2 andv3), wic allows !ou to "uer! ZoneDirector information suc as s!stem status, #$%Nlist, %P list, and clients list, and to set a num&er of s!stem settings using a NetworkManagement S!stem (NMS) or SNMP M' &rowser

*ou can also ena&le SNMP traps to receive immediate notifications for possi&le %P andclient issues

Enabling the SNMP Agent

+e procedure for ena&ling ZoneDirectors internal SNMP agent depends on weter!our network is using SNMPv2 or SNMPv3 SNMPv3 mainl! provides securit!enancements over te earlier version, and terefore re"uires !ou to enterautori-ation passwords and encr!ption settings instead of simple clear te.tcommunit! strings

ot SNMPv2 and SNMPv3 can &e ena&led at te same time +e SNMPv3 frameworkprovides &ackward compati&ilit! for SNMPv/ and SNMPv2c management applicationsso tat e.isting management applications can still &e used to manage ZoneDirectorwit SNMPv3 ena&led

N0+1 or a list of te M' varia&les tat !ou can get and set using SNMP, ceckte related SNMP documentation on te 4uckus #ireless Support #e& siteatttp55supportruckuswirelesscom5documents

If your network uses SNMPv2

To enable SNMPv2 management

/6o to Configure ! System Scroll down to te &ottom of te page and clickte Network Managementlink to open te Network Management section

27nder te SNMPv2 Agentsection, select te Enable SNMP Agentceck &o.

31nter te following information

'n SNMP "# $ommunity(re"uired), set te read8onl! communit! string%pplications tat send SNMP 6et84e"uests to ZoneDirector (to retrieveinformation) will need to send tis string along wit te re"uest &efore te!will &e allowed access +e default value is pu&lic

'n SNMP "% $ommunity(re"uired), set te read8write communit! string

%pplications tat send SNMP Set84e"uests to ZoneDirector (to set certain SNMPM' varia&les) will need to send tis string along wit te re"uest &efore te!will &e allowed access +e default value is private

'n System Conta$t, t!pe !our email address (optional)

'n System &o$ation, t!pe te location of te ZoneDirector device (optional)

9:lick Applyto save !our cangesIf your network uses SNMPv'

To enable SNMPv' management

http://support.ruckuswireless.com/documentshttp://support.ruckuswireless.com/documents

7/24/2019 Ruckus_SNMP.pdf

2/2

/6o to Configure ! System Scroll down to te &ottom of te page and clickte Network Managementlink to open te Network Management section

27nder te SNMPv' Agentsection, select te Enable SNMP Agentceck &o.

31nter te following information for &ot te 4ead 0nl! and 4ead8#riteprivileges

(ser 1nter a user name &etween / and 3/ caracters

Authenti$ation :oose MD; or S