Embed Size (px)
Citation preview
WAFIOS Tube Automation GmbHAm Häuslerain 1679263 Simonswald, Germany
Note scope of delivery and restrictions mentioned in quote © WAFIOS Tube Automation GmbH 2017
Telefon +49 (0) 7683 91900 - 0Telefax +49 (0) 7683 91900 - [email protected], www.wafios-wta.com
RU 8 - 30
Rolling head for RU series end forming machines Precise forming with highest surface quality
Situation:
In the endforming process, a constant residual wall thickness as well as further special requirements on precision and surface texture are required. One example is the accurate surface shape needed to install an O-ring. These might eventually not be fulfilled by a standard production method.
Solution:
The WTA rolling head allows high degrees of forming and assures a high surface quality and constant residual wall thickness of the formed tube area . The three forming rollers in combination with the wedge slide mechanism guarantee precise shaping in the lowest possible cycle time. The mountings for named O-rings can be easily produced with our new tool.
in the same time
Your Benefits:
§Higher degrees of forming achievable§Improvement of surface quality§Increase in homogeneity of the residual wall
thickness of the tube in the formed area§Cutting and forming in one mounting
Available machine types:
§RU 8§ RU 12§ RU 18§ RU 30
