7
Robert W. Whitney Jr. 222 Mahler St. Houma, La 70363 (985)-855-1525 Email Address: [email protected] SUMMARY OF SERVICES I have been working in the Oil & Gas Industry for 32 plus years. Most of my tenure was spent performing Electric Line operations in Cased Hole Completions. I have also done Open Hole Logging, and Plug & Abandonment Operations. I started my career as an e-line helper and worked my way up to an Operator. Due to the downfall of the industry in ‘87, I decided to use my GI Bill to attend college at USAO of Chickasha, Oklahoma, An accredited Liberal Arts College. While attending College to earn my degree in Computer Science, I worked parttime for PSI Snubbing as an Operator 7/7. Upon the 1

Robert W consult Res 2015

Embed Size (px)

Citation preview

Page 1: Robert W consult  Res 2015

Robert W. Whitney Jr. 222 Mahler St.

Houma, La 70363

(985)-855-1525

Email Address: [email protected]

SUMMARY OF SERVICES

I have been working in the Oil & Gas Industry for 32 plus years. Most of my tenure was spent performing Electric Line operations in Cased Hole Completions. I have also done Open Hole Logging, and Plug & Abandonment Operations. I started my career as an e-line helper and worked my way up to an Operator. Due to the downfall of the industry in ‘87, I decided to use my GI Bill to attend college at USAO of Chickasha, Oklahoma, An accredited Liberal Arts College. While attending College to earn my degree in Computer Science, I worked parttime for PSI Snubbing as an Operator 7/7. Upon the completion of college and earning my B.S. degree in Computer Science I went back to the E-line field to continue my work as an Operator/ Engineer. 1995 to present day, I have worked as an E-line Operator/ Engineer. During my time spent in this field I have performed and ran the following tools: 40 Arm Calipers, Tracer Injector Tools, Gyros, Stearing Tools, Gamma Ray -Neutron Tools,

1

Page 2: Robert W consult  Res 2015

Open Hole Suite Tools, Production Packers, Whip-stock Packers, various Perforation Ops, Retainers, Go Packers, CIBP'S, Jet & Chemical Cutters for TBG / CSG, Pulse Neutrons, etc.

During the last 4 years of working with Plug & Abandonment Operations, working not only as an operator but also a Supervisor onsite when needed, I have gained various experience and knowledge with: Slickline Operations, Cased Hole Fishing, Well-Head & Valve

Repair Operations, Slot Recovery & Mechanical Cutting Operations. Throughout my years in P&A and Cased Hole Wireline I have been exposed to and gained knowledge from Slickline, fishing, wellhead, valve repair, hot tap, coiled tubing, stimulation, construction, platform removal, decommissioning and various other services. The combination of my years experience in the field and the higher education that I have obtained make me feel that I would be an asset to any Oil & Gas company.

WORK EXPERIENCE :

Offshore Energy Services / Tong Operator: 10/2013 - Present

- Rig up /Down maintain equipment on location run pipe

- In / out of well

Quality Energy Services / Sr. Operator / Engineer: 7/2012 – 10/2013

2

Page 3: Robert W consult  Res 2015

- I rigged up on Location, loaded guns and maintained the equipment

Tetra Technologies / Sr. Operator / Engineer: 7/2009 – 7/2012

- I set CIBP, dumped cement and cut pipe with jet cutters

- P & A Jobs

- Assisted in Slickline operations

- Assisted in pulling pipe and casing

Proserv P&A / Sr. Operator / Engineer: 11/2007 – 7/2009

- I set CIBP, dumped cement and cut pipe with jet cutters

- P & A Jobs

- Assisted in Slickline operations

- Assisted in pulling pipe and casing

Weatherford Wireline / Open Hole Engineer: 3/2005 - 11/2007

- I ran the full open hole logging suite on wells all over Oklahoma,

- Kansas and Arkansas.

Downhole Wireline / Sr. Operator: 4/2000 - 3/2005

-I rigged up on location, loaded guns and maintained the equipment

Gyro Data / Surveyor / Engineer: 4/1998 – 4/2000

-I ran gyro surveys and steering tools on directional drilling jobs

Halliburton Energy Services / Sr. Operator: 12/91 – 4/98

-I rigged up on location, loaded guns and maintained the equipment

3

Page 4: Robert W consult  Res 2015

PSI Snubbing / Operator: 7/86 - 12/91

- I rigged up on location, repaired equipment as needed and ran pipe in the hole mainly to wash sand.

Apache Oil / Gauger: 6/85 - 7/86

- I would take care of 5 wells on a daily bases.

- I read the charts and calculated daily production for each well and maintain the surface equipment.

OCS Wireline Operator: 5/81 - 6/85

- I rigged up on location, loaded guns and maintained the equipment

EDUCATION

Terrebonne High School Aug. 1973 – May 1977

University Of Science And Arts Aug. 1987 – April 199

REFERENCES

John Leblanc 985-855-0320

Wendell Hall 985-232-2528

Greg Cornwell 985-226-2696

CERTIFICATIONS AND TRAINING4

Page 5: Robert W consult  Res 2015

Twic card First aid/CPR

Blood Borne pathogene Water survival / Huet

Personal basket / swing rope Rigger training

Well control / wireline Randy smith stuck pipe school

Explosive safety Safe gulf

Lock out-tag out Fall protection - rescue

Hazard ID H2S

Respirator fit test

Radiation safety well-logging supervisor

Fire watch / incipient fire / hot works training

5