Upload
others
View
9
Download
0
Embed Size (px)
Citation preview
RF-MFX720 Module series — — multi-protocol spectrum system ( MTSS-Mul ),
specialized for upgrading traditional high-end traismitters
Product Overview: ‘MTSS-Mul’, a 2.4G spectrum transmitting system based on brand-new ‘ONE TO
ALL’ designing idea---supporting DSM2, DEVO and J6Pro at the same time;
Specialized in traditional high-end transmitters upgrades, e.g. JR 9XII,FUTABA T9C,
FUTABA 10CHP and Hitec AURORA-9(directly fixed);
Supporting FS-TH9X-B and Hobbying 9XR(directly fixed);
Supporting transmitters with changeable modules like W-fly;
Supporting HorizonHobby’s products with DSM2 or compatible receivers, e.g.
McpxV1&V2,130-X,MSR-X and UMX;
Supporting Walkera’s Super CP,Mini CP,V120D02S,Master CP and quadrocopters;
Supproting nineeagle’s SOLOPRO 125,SOLOPRO 180D, Solo Pro 319 and any models
that can be controlled by J6 transmitters;
Technical Features: Maximum transmitting power:20Bm;
Channels:9CH(DSM2),8CH(DEVO),6CH(J6Pro);
Working voltage:5~12V;
Working current:100mA;
MTSS-Mul modes and supported receivers
Before opening the transmitter, please select MTSS-Mul mode as following:
MTSS-Mul-A mode(DSM2):F1+A;
Supported receivers/ models:HorizonHobby’s such as McpxV1&V2、130-X、
MSR-X and UMX;
MTSS-Mul-B mode(DEVO):F1+B;
Supported receivers/ models: Walkera’s Super CP,Mini CP,V120D02S,Master
CP and quadrocopters; MTSS-Mul-C mode(J6Pro):F1+C;
Supported receivers/ models:nineeagle’s SOLOPRO 125,SOLOPRO 180D, Solo
Pro 319 and any models that can be controlled by J6 transmitters
Binding Steps MTSS-Mul-A mode(DSM2):
1) First enter a DSM2 receiver into binding mode, then hold the binding button before
opening the transmitter. Release the binding button after opening the transmitter
and the LED on the module will flash;
2) Binding is finished when the LED keeps on;
3) If the transmitter could control the receiver, the binding operation succeeds or
repeat the binding operation from step 1.
MTSS-Mul-B mode(DEVO):
1) Power on a DEVO receiver and then open the transmitter, after that the LED on the
module will flash;
2) When the LED on the receiver or something other(as the receiver’s instructions say)
indicates finishing binding, move the rudder/aileron stick to quit binding.
MTSS-Mul-C mode(J6Pro):
1) First enter a J6Pro receiver into binding mode, then hold the binding button before
opening the transmitter. Release the binding button after opening the transmitter
and the LED on the module will flash;
2) Binding is finished when the LED keeps on.
PS:MTSS-Mul-A mode(DSM2) and MTSS-Mul-C mode(J6Pro) need binding only
once;MTSS-Mul-B mode(DEVO) needs binding every time when opening the
transmitter(as the protocol requires) .
Supported Transmitters: RF-MFX72-F/H supprots:FUTABA T9C,FUTABA 10CHP, Hitec AURORA-9, etc.
RF-MFX72-JR supports :JR 9XII,FS-TH9X-B, Hobbying 9XR, etc.