residential rolling door openers

Controll-A-Door® Power Drive

Roll-A-Pro™

October 2016SECTION 06/1RETURN TO INDEX

Product Code

62887

descriptionThe Controll-A-Door® Diamond PD - Power Drive features the latest technology for efficient, quiet and reliable operation.

CONTROll-A-DOOR DIAmOND PD - POwER DRIvEPART NO. 62482

CONTAINS2 x 4 button keyring transmitter

specificationsmOTOR SPECIfICATIONS

Power Supply 230-240VAC

Transformer Voltage Prim 230-240VAC Sec: 24VAC

Standby Power 2W Consumption

Motor Type Permanent magnet

Motor Voltage 24 VDC

Motor Power 100W

Motor Output Speed 70rpm

Travel Speed (mm/sec) 140/130 Open/Close

Soft Start/Soft Stop Yes

Manual Release Integral motor/clutch type pull/pull

Smart phone Yes control kit ready

Lockable Engage No Disengage

Courtesy Light Yes (variable)

Light Source 2 x LED modules (each with 3 LED’s)

DOOR & mOUNTINg SPECIfICATIONS

Maximum Door Travel 3 turns Limit in Barrel Turns

Short Term Lifting Force 600Nm

Maximum Door Size (Area) 16.5m2

Maximum Door Weight 110kg

Recommended Lateral 95mm Space Requirements

Minimum Lateral 40mm Space Requirements

Opener Weight 7.6kg

Weight Bar 2kg metal filled plastic bottle

TRANSmITTER SPECIfICATIONS

Operating Frequency UHF Multi frequency FM (Tri-Tran™ technology)

Transmitter Capacity 14

Receiver/Transmitter Type UHF Multi frequency FM (Tri-Tran™ technology)

ACCESSORIES

See the residential door opener accessories section.

wARRANTy

Warranty (Years) Full on-site 7 years/ 20,000 cycles

Transmitters Wall Button

Power Driverolling door opener

October 2016SECTION 06/2RETURN TO INDEX

Minimum Sideroom Recommended Sideroom

Product Code

62887

features• Full on-site 7 year/20,000 cycle parts and labour

warranty (if installed by an authorised B&D Dealer).

• “Scalloped” back for easier securing and mounting in tight installations.

• Only needs 40mm sideroom (curtain to inside of bracket) for installation.

• Compatible with PG-3 Programmer.

• LED Lighting - 30,000 hour half-life span with brighter illumination than traditional globes.

• 2W standby power usage.

• Soft start/soft stop operation.

• Vacation and pet modes.

• Battery backup and solar compatible.

• Smart phone control kit ready.

method of operationActivate the operator by either the door control button, outside key switch or keyless entry system, the remote control transmitter or manually open the door, by pulling the release handle down.

lifting capacityMore powerful motor - will readily lift up to a 16.5m2 110kg door (or 3 turns of the drum). 600Nm power.

door typeStandard residential rolling garage doors.

installation requirements/ intructionsThe door must be in good operating condition and the maximum effort to move the door up or down, from stationary, should not exceed 200 Newtons (20kg force) at the bottom rail. The recommended force should be 70N (7kg) for manual operation.

Figures 1 and 2 show the minimum and recommended sideroom that is required to mount the opener. The distance between the edge of the door curtain and the inside of the bracket must be at least 40mm with a total sideroom requirement of 85mm. However, for easier access it is recommended that at least 95mm is allowed for between the curtain and bracket and a total of 135mm from the edge of the curtain to the wall.

NOTE: Door Axle Diameter not to exceed 35mm.

The opener can be installed on either the right hand or left hand side of the door. The opener is set in the factory to Right Hand Side. This opener is not designed for external use. It must be mounted in a dry position that is protected from the weather. Moisture or corrosion may damage the opener and this is not covered by the Warranty. Do not allow water, or other liquids, to enter the opener or remote control transmitter.

Power Driverolling door opener

October 2016SECTION 06/3RETURN TO INDEX

Product Code

62887

spare parts list

Power Driverolling door opener

ITEm NO. PART NO. DESCRIPTION

1 Drive Chassis VR1

2 062077 Clutch Geared Motor Assy 13 WS

3 Hex Serration Head Screw M6x16

4 062066 Transformer TDB-100-143 Kit

5 Cord Grip Grommet SB5P-2

6 062070 Power Cord A.S 1.5m W2P+1R

7 062079 EMC Filter Board EMC-2.01

8 Pan Head Screw W/Washer M4x8

9 Wire Earth Assy 250L

10 Support Chassis VR1

11 Grommet 101422

12 061732 Timing Assy

13 062078 Timing Harness Assy

14 Dust Cover Top

15 Taptite Screw 'P' M4x10

16 Control Board CBR-1 Assy

17 062847 Control Board DCB01-1.02

18 062757 LED Light LL1-1.00

19 062074 Light Diffuser VR1 Assy

20 Mounting Bracket VR1

21 Timing Cover VR1

22 Main Cover VR1 Assy

23 Industrial Saddle

24 062074 Controls Cover VR1

25 062072 Internal Gear 8225-40 Assy

26 062071 Clamp Washer

27 062073 Retaining Ring STW 45

28 U-Bolt M8

29 062076 String Handle Assy

30 Hex Serration Head Screw M8x16

31 Pan Serration Head Screw M4x12

32 Hex Serration Flange Nut M8 (Black)

33 Flat Washer 8.4x18x1.6

34 062063 Accessory Pack Internal Gear VR1

35 Extension Fork 58L

36 Hex Serration Head Screw M6x45

37 Flat Washer 107D 6.4x20.5x1.6

38 059693 Weight Bar

October 2016SECTION 06/4RETURN TO INDEX

Product Code

62887

spare parts

Power Driverolling door opener

October 2016SECTION 06/5RETURN TO INDEX

Product Code

62886

descriptionPossessing advanced technology and features, the Roll-A-Pro™ Rolling Door Opener represents exceptional value.

ROll-A-PRO ROllINg DOOR OPENERPART NO. 062098

CONTAINS062730 - 2 x 2 button transmitter

specificationsmOTOR SPECIfICATIONS

Power Supply 230-240VAC

Transformer Voltage Prim 230-240VAC Sec: 24VAC

Standby Power 2.2W Consumption

Motor Type Permanent magnet

Motor Voltage 24 VDC

Motor Power 100W

Motor Output Speed 70rpm

Travel Speed (mm/sec) 140/130 Open/Close

Soft Start/Soft Stop Yes

Manual Release Integral motor/clutch type pull/pull

Smart phone Yes control kit ready

Courtesy Light Yes

Light Source 2 X LED modules (each with 10LED’s)

DOOR & mOUNTINg SPECIfICATIONS

Maximum Door Travel 3 turns Limit in Barrel Turns

Maximum Lifting Force 500Nm

Maximum Door Size (Area) 15m2

Maximum Door Weight 110kg

Recommended Lateral 95mm Space Requirements

Minimum Lateral 40mm Space Requirements

Opener Weight 7.6kg

Weight Bar 2kg metal filled plastic bottle

TRANSmITTER SPECIfICATIONS

Operating Frequency UHF Multi frequency FM (Tri-Tran™ technology)

Transmitter Capacity 8

Receiver/Transmitter Type UHF Multi frequency FM (Tri-Tran™ technology)

ACCESSORIES

See the residential door opener accessories section.

rolling door opener

October 2016SECTION 06/6RETURN TO INDEX

Minimum Sideroom Recommended Sideroom

Product Code

62886

OThER fEATURES

Obstruction Force Margin Yes

Overload Indicator Yes

Service Indicator Yes

Warranty Indicator Yes

Mains Failure Indicator Yes

Obstruction Indicator Yes

Door Travel Limits Setting Motor driven

wARRANTy

Warranty (Years) 5 years/ 10,000 cycles

features• More powerful motor - will readily lift up to a

15m2 110kg door.

• “Scalloped” back for easier securing and mounting in tight installations.

• Only needs 40mm sideroom (curtain to bracket) for installation.

• Compatible with PG-3 Programmer.

• LED Lighting - 30,000 hour half-life span with brigther illumination than traditional globes.

• 2.2W standby power usage.

• Soft start/soft stop operation.

• Tri-Tran™ coding platform for better reception and less interference.

• Smart phone control kit ready.

method of operationActivate the operator by either the door control button, outside key switch or keyless entry system, the remote control transmitter or manually open the door, by pulling the release handle down.

door typeStandard residential rolling garage doors.

installation requirements/ intructionsThe door must be in good operating condition and the maximum effort to move the door up or down, from stationary, should not exceed 200 Newtons (20kg force) at the bottom rail. The recommended force should be 70N (7kg) for manual operation.

Figures 1 and 2 show the minimum and recommended sideroom that is required to mount the opener. The distance between the edge of the door curtain and the inside of the bracket must be at least 41mm with a total sideroom requirement of 85mm. However, for easier access it is recommended that at least 95mm is allowed for between the curtain and bracket and a total of 135mm from the edge of the curtain to the wall.

NOTE: Door Axle Diameter not to exceed 35mm.

The opener can be installed on either the right hand or left hand side of the door (when viewed from inside the garage). The opener is set in the factory to Right Hand Side. This opener is not designed for external use. It must be mounted in a dry position that is protected from the weather. Moisture or corrosion may damage the opener and this is not covered by the Warranty. Do not allow water, or other liquids, to enter the opener or remote control transmitter.

rolling door opener

October 2016SECTION 06/7RETURN TO INDEX

Product Code

62886

spare parts listwarranty expired indicatorWhen the opener reaches the number of cycles covered by warranty the courtesy light will flash 10 times after each operation to indicate that the warranty has expired. This flashing will continue for twenty (20) operations unless the user acknowledges the warranty expiry indicator and stops the light from flashing.

fault indicatorWhen a fault is detected the service LED will start to flash and a number of beeps will sound to identify the type of fault. The fault will be active each time an attempt is made to operate the door. Pressing the LIMIT SET button will reset the opener. If the fault continues to be tripped contact B&D for assistance.

rolling door opener

ITEm NO. PART NO. DESCRIPTION

1 Drive Chassis VR1

2 062077 Clutch Geared Motor Assy 13 WS

3 Hex Serration Head Screw M6x16

4 062066 Transformer TDB-100-143 Kit

5 Cord Grip Grommet SB5P-2

6 062070 Power Cord A.S 1.5m W2P+1R

7 062079 EMC Filter Board EMC-2.01

8 Pan Head Screw W/Washer M4x8

9 Wire Earth Assy 250L

10 Support Chassis VR1

11 Grommet 101422

12 061732 Timing Assy

13 062078 Timing Harness Assy

14 Dust Cover Top

15 Taptite Screw 'P' M4x10

16 Control Board CBR-1 Assy

17 062847 Control Board DCB01-1.02

18 062757 LED Light LL1-1.00

19 062074 Light Diffuser VR1 Assy

20 Mounting Bracket VR1

21 Timing Cover VR1

22 Main Cover VR1 Assy

23 Industrial Saddle

24 062074 Controls Cover VR1

25 062072 Internal Gear 8225-40 Assy

26 062071 Clamp Washer

27 062073 Retaining Ring STW 45

28 U-Bolt M8

29 062076 String Handle Assy

30 Hex Serration Head Screw M8x16

31 Pan Serration Head Screw M4x12

32 Hex Serration Flange Nut M8 (Black)

33 Flat Washer 8.4x18x1.6

34 062063 Accessory Pack Internal Gear VR1

35 Extension Fork 58L

36 Hex Serration Head Screw M6x45

37 Flat Washer 107D 6.4x20.5x1.6

38 059693 Weight Bar

October 2016SECTION 06/8RETURN TO INDEX

spare parts

Product Code

62886

rolling door opener