Upload
truonghanh
View
222
Download
0
Embed Size (px)
Citation preview
* Follow the steps outlined below to install your Reaper Rack.*The Reaper Racks is delivered in it’s compact shipping form.
REQUIRED ITEMSDrill, 5/16” drill bit, wrench, truck
INCLUDED ITEMS
The RIGHT side of the Reaper Rack has two pre-drilled pilot holes. These pilot holes are the ONLY two locations that require further drilling as outlined in this guide.
Right Side
The LEFT side of the Reaper Rack is pre-drilled and secured with 2 stainless-steel bolts.
Left Side
REAR VIEW
TOP VIEW
1 x Reaper Rack2 x Ramps2 x Stainless Steel bolts2 x Tie-Downs (1” x 8’ )
Rear Tabs
Side Tabs
Slide The Reaper Rack Apart
REAR VIEW OF YOUR TRUCK’S BED
Installation
Slide the Reaper Rack apart to the width of the truck’s bed until the Side Tabs sit snug against the bed.
Slide the Reaper Rack to the front of the truck’s bed until the Front Tabs sit snug against the bed.
FRONT OF TRUCK
Rear End
Now you are ready to drill your two holes all the way through the sliders witha 5/16 drill bit, and install the bolts with the nuts.
Using a drill and a 5/16” drill bit, drill all the way through the two pilot holes located on the RIGHT side of the rack.
Install the two included stainless steel bolts into the newly drilled holes and secure them with the nuts.