Upload
others
View
3
Download
0
Embed Size (px)
Citation preview
15.78 hrs
2 pcs
f
0.25 mm
k
0.40 mm
h
8
494.00 g
d
MK3S +MMU2S
Summary
Version of the RC3 face shield to be made with A4 laminator sheet. Onlyneeds 1 laminator sheet for entire face shield. DXF included for upper andlower visor template
Band adjusted to 17mm high. This results in the part being the sameweight and taking the same amount of time to print as the RC3 version.
(Paper used in photos as it turns out photographing clear plastic is reallyvery difficult!)
Healthcare > Accessibility
laminating laminator shield ppe face covid
GCODE included for single version and 12 (2 stacks of 6) in PETG based onPrusa high speed print settings.
P Pippa
RC3 Face shieldwith upper sectionvisor for extraprotection
VIEW IN BROWSER
updated 31. 3. 2020 | published 31. 3. 2020
Print Files (.gcode) DOWNLOAD ALL FILES
2.9 MB
1.11 hrs f 0.25 mm k 0.40 mm h PET 37.40 g d MK3S +MMU2S
updated 31. 3. 2020
39.1 MB
14.67 hrs f 0.25 mm k 0.40 mm h PET 457.00 g d MK3S +MMU2S
updated 31. 3. 2020
Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES
100.0 KBupdated 31. 3. 2020
2.1 MBupdated 31. 3. 2020
4.2 MBupdated 31. 3. 2020
This remix is based on
Prusa Protective Face Shield Cover - RC1 (WIP)
by Prusa Research
single-mask-with-visor-slot.gcode
rc3s-x12-petg-high-speed.gcode
visor-template.dxf
rc3s-x4.stl
rc3s-x8.stl
1.1 MBupdated 31. 3. 2020
3.2 MBupdated 31. 3. 2020
License
This work is licensed under a Creative Commons (4.0 International License)
Attribution-NonCommercial
✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✖ | Commercial Use ✖ | Free Cultural Works ✖ | Meets Open Definition
rc3s-x2.stl
rc3s-x6.stl