AUREL RADIO FREQUENCY MODULES 2010
new Contact for information: Mr. Gensler Tel. +49(0)7452-6007-31
e-mail: [email protected]
Wireless modules design and production for wide range
applications: radio modems for automatic meter reading (AMR).
Wireless modules for telemetry systems, wireless sensors network,
wireless alarms and security systems, home and building automation,
industrial monitoring and control. Suitable for ISM band
frequencies as 433 MHz, 868 MHz and 2.4GHz.What is new? MID RF
LineSmall dimension Receiver, Transmitter and Transceiver modules.
A unique line of products same size.
new
DESCRIPTION
Printed circuit version of the well established AC-RX2
assembled. This will be the low cost receiver for the future and
replace BC-BNK and the AC-RX receiver versi-ons based on alumina.
The receiver is built on FR4 material, offer same pin out as the
alumina version.
Not new but unique. Low cost, low current consumption micro amps
RF receiver. Typical current consumption at full operation only
0.07 mA.High selectivity and high insensitivity to electromagnetic
fields from installed input SAW filter and shielded case. Perfect
for battery powered systems.
Super-het receiver of AM modulated digital data, working at
433.92 MHz frequency. Pin to pin compatible with all OOK AUREL
receivers. High selectivity and sensitivity obtained by a front-end
SAW filter. Ideal for applications needs a higher noise im-munity,
e. g. created by brushes electrical motor.
High sensitivity and sensibility super-het FM receivers:
RX-FM4SF 433.92, RX-FM4SF 434.15, RX-FM8SF 868.30, RX-FM8SF
869.50.Front-end SAW filtered to a higher electromagnetic immunity.
Enable pin allows power-down mode without signal and reduces
consumption down to 0.5 A. The receivers are pin compatible. Ideal
for Microchip Keeloq encoders. Easy change in the design phase from
433 MHz to 868 MHz. Just adapt antenna.
Printed circuit version of the well established TX-SAW MID 3V
and 5 V assembled on alumina substrate. The transmitter build on
FR4 material, offers same pin out as the alumina version. More
robust against mismatching problems of antenna design.
AC-RX2/CS
RX-FM4SF--- RX-FM8SF
RX-4M30RR01SF
TX-SAW MID 3V/CSTX-SAW MID 5V/CS
RX-4MM3/F --- RX-4MM3++/FRX-4MM5/F --- RX-4MM5++/F
Start your design with the transmitter frequency of your choice
and be flexible during the design process. The Transmitters are pin
compatible and easy to change from 433MHz-AM to 433MHz-FSK or 868
MHz-FSK while pcb design keep untouched. The new short form
catalogue is a useful tool to find the right product in short time.
Specific data sheets as well as application notes and further
products, you will find as usual at our web page
www.endrich.com.
AUREL RADIO FREQUENCY MODULES 2010
Contact for information: Mr. Gensler Tel. +49(0)07542-6007-31
e-mail: [email protected]
DESCRIPTION
Mini ASK transceiver module with high sensitivity and power-down
functionality - Ideal for a 2-way radio system needing to save
space and battery life. Its ideal for low cost solutions, battery
supplied and thanks to its small size to hand held terminals.Max.
speed rate is 10 Kbit/sec and its compatible with RS232 standard
@9600 bps (TTL levels), not requiring any balancing of data. The
device can work in compliance with HCS Microchip data frame. All
transceiver features can be handled by 4 lines (RX/TX, ENABLE, DATA
IN, DATA OUT). The module is available as 3V and 5V version.
Handheld 868 MHz and 433 MHz with HCS301 rolling code encoder.
Ideal for remote control applications requiring high security
level. High performance from 3V lithium battery. Null consumption
in stand-by mode.For 433 MHz a receiver module with embedded
decoder (RX-4MHCS) is available. 868 MHz Receiver with embedded P
be under way.
TX 869 Boost 0.5 W is a multi-channel FSK transmitter module
operating in the ISM band, 869.4 - 869.65 MHz with external antenna
for transmission of digital data cover long distances (above 1 km),
according to Decision 2006/771/EC of the European Union for use in
time of 10 % measured on an hourly basis.Very low power consumption
in stand-by (< 1A), very fast wake-up and possibility of
external regulation of the wanted power, ideal for battery powered
systems. Conforms to European EN300 220 and EN300 489. Suitable
receiver: RX-FM8SF 869.50.
RF transmitter, FSK modulation, working at 868 MHz and 433 MHz
band at same time. Useful for LPD applications. Pin to pin
compatible with AUREL module TX SAW s/Z or TX MID Line
transmitters. Suitable for home alarm applications when it is
requested a high security in data transmission and electromagnetic
immunity. Demoboards are available.
New wide angle low-power coverage PIR detector mod. SIR 2008
HCS/HT12E with built-in coded RF SAW transmitter. Encoder chosen
via micro switch. Available also in dual band: 434.15 MHz and
868.30 MHz.
Encoders: Random codes (HCS Keeloq Microchip) or Fixed code
(HT12E), also available with Motorola 5026 code.
Called plug & play, it is pre-configured ZigBee network
composed of routers modules only: no need for coordinator, related
controller, net creation and maintenance. Only simple node
controllers needed for modules functional binding and net
operation.
ZigBee technology is well suited to a wide range of energy
management and efficiency, building automation, industrial,
medical, health care & wellness and home applications that need
a low consumption monotoring. Enjoy your business with the easiest
and smart wireless solution.
TRANSCEIVER RTX MID 3 V & 5 V
DUAL TRANSMITTER TX-FM434/868 & ...434/868 MID
HANDHELD AM TRANSMITTER
SIR 2008
TX 869 BOOST
ZIGBEE TRANSCEIVER ANDPLAG & PLAY ZIGBEE NETWORK
Demoboards are available
