8/18/2019 r2 Design Example 2013rev1 http://slidepdf.com/reader/full/r2-design-example-2013rev1 1/1 © Peter Watt 2013 R2: Example. Reinforced Brickwork Beam Design a simply supported reinforced brickwork beam to clear span 3,80m carrying a characteristic dead load of 20,0kN/m (includes self-weight) and a characteristic single imposed load of 8,0kN/m. The bricks to be used have a declared (air dry) compressive strength (non-normalised) of 55N/mm 2 and are of Group 1 configuration with the manufacturing control being category I. The mortar is class M6, (designation ii) General Purpose mortar and the masonry work is to class 1 execution control. Figure 1: Elevation and section of the reinforced beam 3.8m clear span Floor construction Reinforced masonry Section Reinforced masonry

r2 Design Example 2013rev1

Download PDF Report

Upload
will-harrow
View
214
Download
0

Embed Size (px)

Citation preview

8/18/2019 r2 Design Example 2013rev1

http://slidepdf.com/reader/full/r2-design-example-2013rev1 1/1

R2: Example. Reinforced Brickwork Beam

Design a simply supported reinforced brickwork beam to clear span 3,80m carryinga characteristic dead load of 20,0kN/m (includes self-weight) and a characteristic

single imposed load of 8,0kN/m. The bricks to be used have a declared (air dry)compressive strength (non-normalised) of 55N/mm2 and are of Group 1configuration with the manufacturing control being category I. The mortar is classM6, (designation ii) General Purpose mortar and the masonry work is to class 1execution control.

Figure 1: Elevation and section of the reinforced beam

50.00 3.8m clear span

Floor construction Reinforced masonry

Section

Reinforced masonry