-
7/26/2019 QUIZ 1st Day
1/3
QUIZTo pass you must score 80 or higher.
1 In expansion bays, 4100U Option Cards are connected to the
_____.
PDM.
Master Controller Motherboard.
System Power Supply.
PDI.
2 The System Power Supply gets AC power by way of the
Master Controller.
PDM.
Master Controller Motherboard.
PDI.
3 Slots are designated by
Numbers 1-8.
factory programming.
installer choice of letters or numbers.
Letters A-H.
4 AC Power from the electrical main is connected to the panel at
the
System Power Supply.
Master Controller Motherboard.
PDI.PDM.
5 Backup Batteries are connected to the
PDI.
System Power Supply.
-
7/26/2019 QUIZ 1st Day
2/3
PDM.
Electrical Main
6 By default, Bay 1 is configured as
the CPU Bay.
an Expansion Bay.
an Annuciator Panel.
7 Installing a 4100 Option (legacy) card in a 4100U system
requires that you
plug it into the PDI and screw it to the backplane.
retrofit the panel.
install an Expansion Power Supply in the Expansion Bay to
provide power to the legacy
board.mount a motherboard in the Expansion Bay first.
8 (CHOOSE 3) Essential modules in the CPU Bay are:
Master Controller
Master Controller Motherboard
System Power Supply
Legacy Card
4100 Option Card
9 _____ can accommodate modules installed in any combination of
slots and blocks.
Both CPU Bay and Expansion Bays
CPU Bays
Expansion Bays
10 4100U Expansion Bays contain
the System Power Supply and Master Controller.
a variety of modules depending on the system requirements.
the CPU Bay.
the PDM.
-
7/26/2019 QUIZ 1st Day
3/3
11 If you are installing a new card in an Expansion Bay, you
must first
verify that the Master Controller is communicating with the
bay.
ensure that you have a spark at P4.
remove the harness that provides power to the bay door
modules.
disable the power to the bay.
12 The purpose of the retention bar is to hold the _____ in
place.
bay doors
power supplies
motherboards
legacy cards
13 (CHOOSE 2 ANSWERS) To designate the position of a module in
programming, the bay
space is divided into _____ and _____.
ports
boxes
slots
blocks
sockets
14 Blocks are designated by
installer choice of letters or numbers.
Numbers 1-8.
Letters A-H.
Factory programming.
After you have completed the test and are satisfied with your
answers, please call the instructor
