Upload
others
View
1
Download
0
Embed Size (px)
Citation preview
Quick Start Guide
Phone numbers E-mail and Web ID Headquarters +420 725 877 063 [email protected] Reg. No.: 29048575 Libocka 653/51b +420 725 955 464 www.workswell.eu VAT No. CZ29048575 Prague, Czech Republic
Revision 1.0 EN, 17.1.2017 All pictures are only for illustration.
Real values may vary.
Please do not operate the device until you read this document in detail
and until you are sure you understand all the instructions written there.
If you are not sure, please read full user manual or contact your local
dealer or Workswell s.r.o. support on [email protected].
Failing above may result in permanent damage which is not part of
warranty.
Please check that your delivery contains all the items listed below. It can be occasionally extended by additional accessories such as temperature filter, lens etc. according to your order.
Before you start using your Workswell WIRIS MINI, make sure that you
also have the following:
Disclaimer
▪ WIRIS MINI head with lens
▪ Calibration certificate
▪ Image correction cap
▪ Micro SD card
▪ HDMI cable 80 cm
▪ Power supply cable
▪ Servo connectors (2x)
▪ Analogue video cable
▪ Software license CorePlayer
▪ Hard transport case
Package Content
▪ Power source (7 to 28 VDC, 1.5 A)
▪ Radio system with 2 available channels (or USB2.0 Keyboard)
▪ Wireless video link with HDMI (or Display) or analogue
Phone numbers E-mail and Web ID Headquarters +420 737 547 622 [email protected] Reg. No.: 29048575 Libocka 653/51b +420 725 955 464 www.workswell.eu VAT No. CZ29048575 Prague, Czech Republic
Wo
rksw
ell
WIR
IS M
INI
Revision 1.0 EN, 17.1.2017 All pictures are only for illustration.
Real values may vary.
Do you need anything else?
User Manual
If you need any other accessories, please check our website (www.drone-
thermal-camera.com) or contact our partner.
Full user Manual is available in electronic form on the website:
http://www.workswell.eu/documents/
WIRIS MINI Head
Phone numbers E-mail and Web ID Headquarters +420 725 877 063 [email protected] Reg. No.: 29048575 Libocka 653/51b +420 725 955 464 www.workswell.eu VAT No. CZ29048575 Prague, Czech Republic
Revision 1.0 EN, 17.1.2017 All pictures are only for illustration.
Real values may vary.
Phone numbers E-mail and Web ID Headquarters +420 737 547 622 [email protected] Reg. No.: 29048575 Libocka 653/51b +420 725 955 464 www.workswell.eu VAT No. CZ29048575 Prague, Czech Republic
Wo
rksw
ell
WIR
IS M
INI
Revision 1.0 EN, 17.1.2017 All pictures are only for illustration.
Real values may vary.
Infrared camera lens
Maintenance
The Workswell WIRIS MINI camera is focused to infinity. The focus of the
lens is neither possible nor necessary.
Cleaning the WIRIS MINI head and cables
Liquids: Use one of these liquids:
- Warm water
- A weak detergent solution
Equipment: A soft cloth
Procedure: 1) Soak the cloth in the liquid.
2) Twist the cloth to remove excess liquid.
3) Clean the part with the cloth.
Cleaning the infrared lens
Liquids: Use one of these liquids:
- A commercial lens cleaning liquid with more than 30%
isopropyl alcohol
- 96% ethyl alcohol (C2H5OH)
- DEE (= „ether“ = diethylether, C4H10O)
- 50% acetone (= dimethylketone, (CH3)2CO)) + 50%
ethyl alcohol (by volume). This liquid prevents drying
marks on the lens.
Equipment: Cotton wool
Procedure: 1) Soak the cotton wool in the liquid.
2) Twist the cotton wool to remove excess liquid.
3) Clean the lens one time only and discard the cotton
wool.
Phone numbers E-mail and Web ID Headquarters +420 725 877 063 [email protected] Reg. No.: 29048575 Libocka 653/51b +420 725 955 464 www.workswell.eu VAT No. CZ29048575 Prague, Czech Republic
Revision 1.0 EN, 17.1.2017 All pictures are only for illustration.
Real values may vary.
How to start?
Warning:
Make sure that you read all applicable MSDS (Material Safety Data
Sheets) and warning labels on containers before you use a liquid: the
liquids can be dangerous.
Caution:
- Be careful when you clean the infrared lens. The lens has a delicate anti-
reflective coating.
- Do not clean the infrared lens too vigorously. This can damage
antireflective coating. Re-applying antireflective coating is not possible
and is required to change the lens.
Before every use, please check the correct polarity and voltage before
plugging any cables into the camera.
1) Connect the system to a wireless
video link or a monitor using
micro HDMI cable (included).
If you are using an analog video
transmitter, connect the cable
via analog connector.
Display
(not included)
Phone numbers E-mail and Web ID Headquarters +420 737 547 622 [email protected] Reg. No.: 29048575 Libocka 653/51b +420 725 955 464 www.workswell.eu VAT No. CZ29048575 Prague, Czech Republic
Wo
rksw
ell
WIR
IS M
INI
Revision 1.0 EN, 17.1.2017 All pictures are only for illustration.
Real values may vary.
Screen layout
Please, use genuine accessories from Workswell company only to avoid
the risk of damage of the device.
As soon as the system starts, you will see the following screen.
2) Connect the system to a standard
RC receiver using at least 2 servo
cables (included) or S.Bus. Use
input 1 and 2 in order to control
main functions. Alternatively, you
can connect keyboard via USB
port.
RC receiver
(not included)
2x
3) Connect the power supply using
power supply cable (included).
Red wire is +7 to +28 VDC, black
wire is GND.
+7-28 VDC
GND
Phone numbers E-mail and Web ID Headquarters +420 725 877 063 [email protected] Reg. No.: 29048575 Libocka 653/51b +420 725 955 464 www.workswell.eu VAT No. CZ29048575 Prague, Czech Republic
Revision 1.0 EN, 17.1.2017 All pictures are only for illustration.
Real values may vary.
▪ Main camera window shows live stream from selected camera. You
can switch between infrared and visible spectrum camera during
the flight.
▪ Camera preview window shows live stream from camera that is not
shown in Main camera window.
▪ Status bar brings you most important information about the system.
▪ Temperatures window informs you about temperatures in the
measured scene.
Main camera window Camera preview window
Temperatures window Status bar
Phone numbers E-mail and Web ID Headquarters +420 737 547 622 [email protected] Reg. No.: 29048575 Libocka 653/51b +420 725 955 464 www.workswell.eu VAT No. CZ29048575 Prague, Czech Republic
Wo
rksw
ell
WIR
IS M
INI
Revision 1.0 EN, 17.1.2017 All pictures are only for illustration.
Real values may vary.
System control
Workswell WIRIS MINI is designed to be controlled remotely using
standard RC system. For this case, WIRIS MINI system is equipped with
4 digital IO Ports and one S.Bus port. First two Digital IO Ports serve as the
Up/Down and Enter/Escape buttons. The other ones can be used as
a shortcut to important functions (mode switching, recording video,
image capturing, zoom, etc.).
It is also possible to control the system on the ground using standard
USB2.0 keyboard.
All the settings can be done via the system menu. The menu can be
opened by clicking the Enter key on a keyboard.
It is recommended to use a joystick for navigation in the menu. If
connected as recommended, the joystick has the following behaviour.
Phone numbers E-mail and Web ID Headquarters +420 725 877 063 [email protected] Reg. No.: 29048575 Libocka 653/51b +420 725 955 464 www.workswell.eu VAT No. CZ29048575 Prague, Czech Republic
Revision 1.0 EN, 17.1.2017 All pictures are only for illustration.
Real values may vary.
Non-uniformity Correction (NUC)
(NUC)
Turning the system off
Digital Input Keyboard Function
1 Up/Down Up/Down
2 Enter/Esc Enter/Escape
3 F6 Capture (default)
4 F7 Record (default)
5* F5 Change mode (default)
* If the S.Bus expansion is used, this port can be used for the S.Bus
interface also.
In most cases, the non-uniformity (NU) is a time-dependent noise caused
by the lack of sensor equalization. It leads to a structured noise in the
image and it must be corrected. For this device, NUC is performed by
attaching NUC cap to the camera lens.
To switch the camera off, simply unplug the power supply.
Enter/Menu Escape
Down
Up
Phone numbers E-mail and Web ID Headquarters +420 737 547 622 [email protected] Reg. No.: 29048575 Libocka 653/51b +420 725 955 464 www.workswell.eu VAT No. CZ29048575 Prague, Czech Republic
Wo
rksw
ell
WIR
IS M
INI
Revision 1.0 EN, 17.1.2017 All pictures are only for illustration.
Real values may vary.
Sales Department Headquarters Partners Worldwide
Mobile: +420 737 547 622 Workswell s.r.o.
E-mail: [email protected] Libocka 653/51b Visit our website for more details
160 00, Prague 6
Czech Republic
Company contact details
Mobile: +420 725 877 063
E-mail: [email protected]
Web: www.drone-thermal-camera.com
Contacts