Embed Size (px)
Citation preview
German
Innovation
The DOG-e-walkVersatile useable • Suitable for every dog breed • Affordable best price offer • Independent training • Quick successful learning • processStress-free walks and training •
Your specialized DOG-e-walk dealer:
Until which range does the DOG-e-walk work?The maximum range of the DOG-e-walk is 10 meters. In that moment where you • don´t focus the device on the dog, the signal is inaudible for him.
Do other dogs around him get irritated by the signal?No! The speaker gives a direct signal to the dog’s ear. This means the signal • does not spread. It remains concentrated so that other dogs nearby do not get irritated.
Is the DOG-e-walk waterproof?The DOG-e-walk is of course splash-water protected and enables the training • even at adverse weather conditions.
Is the DOG-e-walk suitable for all dog breeds?Yes! Independently from the dogs breed, size and weight•
How can I recompense my dog during the training best?There are different ways to recompense your dog. Praise and stroke him • exorbitant, if your dog is listening to your command. In addition you can give him treats, too or combine both.
My dog is very heavy; does the DOG-e-walk work under extreme tensile loading?The DOG-e-walk is tested for all dog breeds and sizes. It is also suitable for dogs • with a heavy weight.
How often can I use the device?You can use it always, but the purpose of the DOG-e-walk is, that after several • practises you won´t need the device anymore, because your dog has learned that taking a walk without pulling the leash is much more convenient.
Which battery does the DOG-e-walk require?The DOG-e-Walk requires a 9 volt block battery.•
Questions and answersabout the all-in-one DOGTRAINER
Is the DOG-e-walk also suitable for older dogs?While getting older the dogs – like humans- are losing the ability of hearing. It • diversifies on the physical condition of the dog, but in general it is also suitable for older dogs.
For what reason do I need the covers of the DOG-e-walk?The covers are for the protection of the DOG-e-walk, especially for the • loudspeaker. Please only remove the covers just before of setting up the DOG-e-walk between the leash and the collar and keep the covers carefully. Use the enclosed snap hooks in the packaging to connect the device between collar and leash. If you want to use the device as remote-contorl/ clicker for agility training with the dog, please remove the snap hooks and protect the DOG-e-walk with the covers again.
Can I practise with more than one dog simultaneously?
For a quick successful training, it is useful to • practise with one dog only, because the dogs could irritate each other, so they won’t pay attention to the exercises you are trying to teach. But if you have the possibility to place the second dog, that he could study what the first dog is doing without irritating, it might be possible that the second dog also receives a successful practise through the imitation effect.
Questions and answers
Training tips
Remote function Leash adapted
The all-in-one dog trainerUse natural instincts to teach
Leash-pulling was yesterday…!
Basic training Agility trainingAnti leash pulling training
Dog school training
In order to get the best results, please always position yourself so that your dog 1. can see you well.
Also support your command by using the well known hand-signs e.g. pointing 2. your finger whilst giving the command “Sit!”, or showing a flat hand (as to say stop) whilst giving the command “Stay!”
Turn off the DOG-e-walk. Give the command “Sit!”3.
If your dog does not react immediately to the command 4. (within 2 seconds), then press the +button once on the volume control.
If your dog reacts to the signal now turn 5. off the volume via the –button. (All LED‘s are off.) Praise your dog. (Award giving method.) As an alternative you can also give your dog a treat for good behaviour.
Training basics How does the dog learn with theDOG-e-walk?
By learning through association!
It is educationally grounded that self-motivation is always stronger than external-motivation.For this reason we have to use the dog’s self-motivation and promptly praise him for his good behaviour.
A signal is released as soon as the dog starts pulling on the leash. The more the dog pulls, the louder the signal gets. The less he pulls, the quieter the signal gets.
You want to train your dog without a leash and teach him certain commands? No problem! This practice is based on the condition that your dog is familiar with the command for example “Sit!”
Pulling the leash was in the past!Anti-leash- pulling-training
Remote controlAs remote control trainer / clicker
Tips and tricksaround the DOG-e-walk
Support your dog through praise and attention regarding to his dislike to the signal. It won‘t take long for him to associate his pulling on the leash with the signal and for him to change his behaviour.
With the remote control function, you can even use the DOG-e-walk without a leash.
The +/- function enables you to regulate • (increase/decrease) the volume of the signal level that you have chosen.
After just a few days it will be possible to go on a relaxed walk with your dog.
1. Connect the DOG-e-walk (orientation of the speaker towards the dog) with the snap hooks between the leash and the dog.
2. Make sure that the DOG-e-walk is turned off during the first few walks, so that your dog gets used to the new weight of
the leash and considers it as “normal”.
3. If you want to practise with your dog, switch on the DOG-e-walk. Before he starts to pull on the
leash start with the command: “Heel!”
4. As soon as the dog starts pulling on the leash, pull him back. Now the device releases an ultrasonic signal that increases/decreases according to the pressure on the leash. (The signal strength depends on how heavy the dog pulls.)
5. If he is coming back recompense him immediately by giving him a treat or by praising or by praising and stroking.
The more you pay attention to your dog, the closer will be the relationship to him. 1.
A busy dog is a satisfied dog. Do not always use the same strolling route. Create 2. new incentives and let your dog meet new fellows. Maybe you will have interesting acquaintances, too.
To figure out, how sensitive your dog is, start the first practise with level 1 and 3. adjust the level only on the next walk. So you prevent irritations.
Start with a slow and relaxed walk, to let 4. him get used to the DOG-e-Walk.
Prevent to repeat commands 5. too often. Thereby you always give him the possibility to choose.
If your dog still ignores 6. your commands- increase the signal on the second time.
The all-in-one dog trainerUse natural instincts to teach
In order to get the best results, please always position yourself so that your dog 1. can see you well.
Also support your command by using the well known hand-signs e.g. pointing 2. your finger whilst giving the command “Sit!”, or showing a flat hand (as to say stop) whilst giving the command “Stay!”
Turn off the DOG-e-walk. Give the command “Sit!”3.
If your dog does not react immediately to the command 4. (within 2 seconds), then press the +button once on the volume control.
If your dog reacts to the signal now turn 5. off the volume via the –button. (All LED‘s are off.) Praise your dog. (Award giving method.) As an alternative you can also give your dog a treat for good behaviour.
Training basics How does the dog learn with theDOG-e-walk?
By learning through association!
It is educationally grounded that self-motivation is always stronger than external-motivation.For this reason we have to use the dog’s self-motivation and promptly praise him for his good behaviour.
A signal is released as soon as the dog starts pulling on the leash. The more the dog pulls, the louder the signal gets. The less he pulls, the quieter the signal gets.
You want to train your dog without a leash and teach him certain commands? No problem! This practice is based on the condition that your dog is familiar with the command for example “Sit!”
Pulling the leash was in the past!Anti-leash- pulling-training
Remote controlAs remote control trainer / clicker
Tips and tricksaround the DOG-e-walk
Support your dog through praise and attention regarding to his dislike to the signal. It won‘t take long for him to associate his pulling on the leash with the signal and for him to change his behaviour.
With the remote control function, you can even use the DOG-e-walk without a leash.
The +/- function enables you to regulate • (increase/decrease) the volume of the signal level that you have chosen.
After just a few days it will be possible to go on a relaxed walk with your dog.
1. Connect the DOG-e-walk (orientation of the speaker towards the dog) with the snap hooks between the leash and the dog.
2. Make sure that the DOG-e-walk is turned off during the first few walks, so that your dog gets used to the new weight of
the leash and considers it as “normal”.
3. If you want to practise with your dog, switch on the DOG-e-walk. Before he starts to pull on the
leash start with the command: “Heel!”
4. As soon as the dog starts pulling on the leash, pull him back. Now the device releases an ultrasonic signal that increases/decreases according to the pressure on the leash. (The signal strength depends on how heavy the dog pulls.)
5. If he is coming back recompense him immediately by giving him a treat or by praising or by praising and stroking.
The more you pay attention to your dog, the closer will be the relationship to him. 1.
A busy dog is a satisfied dog. Do not always use the same strolling route. Create 2. new incentives and let your dog meet new fellows. Maybe you will have interesting acquaintances, too.
To figure out, how sensitive your dog is, start the first practise with level 1 and 3. adjust the level only on the next walk. So you prevent irritations.
Start with a slow and relaxed walk, to let 4. him get used to the DOG-e-Walk.
Prevent to repeat commands 5. too often. Thereby you always give him the possibility to choose.
If your dog still ignores 6. your commands- increase the signal on the second time.
The all-in-one dog trainerUse natural instincts to teach
