Product service conditions

Temperature range, °C - 40... +40Relative humidity of air, % 45 … 80

Manufacturer guarantee

The manufacturing company provides guarantee certificates for a product within 12 months from the date of sale.

Guarantee repair is not made in the cases of:

1. Expiration of product guarantee period;2. Product failure as a result of misconnection;3. Damages caused by ingress of moisture on printed-circuit board;4. Excess of the maximum electric parameters;5. In the presence of scratches of mechanical influences.

Serial number _________________

Manufacturing date ________________

Mark on putting into operation.

Date of sale ____________________

Stamp of trading organization.

603000, 4A Nesterova str., Nizhny Novgorod, Russia

Е-mail: denis@maksbright.cominfo@maksbright.comwww.maksbright.com

Short description

Sigma Optima RGB DMX is slave device in the DMX512 standard. It is intended to control of low-voltage lighting equipment. Area of use extends on decorative illumination, festive illumination, show equipment, and also a wide range of individual tasks of the specific consumer.

Technical characteristics

Number of channels, piece 3Supply voltage of direct current, Volt 4... 25The maximum admissible current on one channel, Ampere 10Total admissible current, Ampere 30Indicator of initial number of channels in the DMX line YesInterface standard DMX protocolThe maximum number of channels in the DMX line, pcs 512Total maximum capacity of channels at 12 V, W 360Input signal PWMQuantity of gradation of brightness for 1 channel, bit 256Maximum frequency of dimming, Hz 128Protection against short circuit yesGalvanic isolation of data yesAmplifier of the DMX line yesBuilt-in terminator (loading resistor) yesWeight no more than, g 330Overall dimensions, mm 115х65х40Protection class IP655

Purpose of controlling elements and indications

1 - output terminal block of connection of the DMX line;2 - indicator of data on the output terminal of the DMX line;3- reduction/increase buttons (left/right) of initial number of channels in the DMX line;4 - indicator of initial number of channels in the DMX line; 5 - terminal blocks of connection of light-emitting diode lines;6 - indication of operation of channels;7 - terminal blocks of connection of the power unit;8 - indication of existence of short circuit in one of the channels;9 - indication of operation of the microcontroller;10 - connection of the loading resistor to the DMX line (the jumper is installed at the end of the DMX line);11 - indicator of data on the input terminal of the DMX line;12 - input terminal block of connection of the DMX line.

Connection scheme of Sigma Optima RGB DMX

The software and documentation are presented on www.maksbright.com.

D-

D+

D-

D+

RG

B

4...2

5V

Pow

ersu

pply

~220V

Уст

рой

ство

(све

тиль

ни

к)R

GB

D-

D+

D-

D+

RG

B

4...2

5V

Pow

ersu

pply

~220V

Dev

ice

(све

тиль

ни

к)R

GB

InputOutputInputOutput

DM

X s

igna

l

To

the

foll

owin

gS

igm

a O

ptim

a R

GB

DM

X