Upload
others
View
3
Download
0
Embed Size (px)
Citation preview
Easy installation
Compact bubble sensor for an exact water level measurement
Building site
Measuring site
Pneumatic gauge
Pressure sensor pneumatic gauge PS-Light-2
www.seba.de D03_PS-Light-2_e 22.05.2019
Application at a river
l Economic measuring system acc. to the bubble principle
l Highly precise and robust by drift free sensing
l Compensation of temperature influence
l Processor supported sensor linearisation
l Low energy consumption thanks
l Optionally with RS485, SDI-12, 0/4..20mA, 0..1V, 0..5V, BCD-, Binary- or Gray-Code output
to intelligent pump control
l Modular system
Short description
PS-Light-2
PS-Light Station
Installation togetherwith Powerbox
Description
The SEBA-pneumatic gauge type PS-Light-2serves as a robust, economic and reliable measuring system for monitoring water levels in surface waters. The measuring principle is the proportioning or bubbler system, based upon the other well-known SEBA instruments in the PS-series.An integrated, highly efficient mini compressor, bubbles air through the pressure tube into the water at adjustable intervals. The resultant pressure in the tube corresponds exactly to the hydrostatic pressure above the mouthpiece. This tube pressure is then measured by a very accurate pressure sensor in the PS-Light-2 .
The intermittent operation of the PS-Light-2 allows low energy consumption, and enables operation with batteries or solar panels, without the need for mains power supply.
The basic version of the is a sensor PS-Light-2with optional output. However it can be equipped with LC-display, datalogger or remote data transfer via mobile data. The basic version is delivered in a robust protective housing (IP65) suitable for wall or desk mounting. SEBA PS-Light-2 can be connected to existing pressure tubes at any time.
pressuretube
pneumatic gauge PS-Light-2
mouthpiece
- sensor with analogue or digital output
- 0/4..20mA
- BCD-Code, Gray-Code, Binary-code
Individually available as:
- data transmission system with mobile modem
Options:
- sensor with SEBA datalogger
1. LC-display2. output signals: galvanically separated - Rs485, SDI-12
- 0..1V, 0..5V
mouth piece / orifice
bubblertube
key for manual purging
signal output0...5V, opt. 0/4...20mA, Gray, BCD, Binary
air inlet zero set
RS232 (optional USB)Configuration & readout interfacefor connection to HDA, Laptop etc.
supplyenable
pressure compensation
sensor Rs485 interface/SDI-12
SEBA data loggerintegrated
online
online
on
lin
e
offline
mobile data, FTP-Push, SMS data transmission
Notebook
- data logger of other manufacturers- SPS - Data Transmission Systems
PS-Light-2
HDA-Tablet
Data flow
PS-Light-2 Variations
0..
1V,
0..
5V,
0/4
..20m
A
PS-L
ight-
2-S
ensor
BCD
, G
ray,
Bin
ary
PS-L
ight-
2-S
ensor-
LCD
Rs232(Rs485)SDI-12
BCD
, G
ray,
Bin
ary
PS-L
ight-
2-L
CD
PS-L
ight-
2-3
G+
0..
1V,
0..
5V,
0/4
..20m
A
PS-L
ight-
2
mobilemodem
consisting of:PS-Light - 2 Sensor
— Plastic Protection Housing
— Highly accurate pressure sensor for mea-
suring the water level
— Output: can be chosen
— Miniature compressor
same as PS-Light-2 Sensor but additionally with:PS-Light- 2 (-Logger)
— Data Logger
with RS232 interface
PS-Light - 2 - 3G+
— with integrated mobile modem— for online- and offline operation
— LC-Display for digital indication
of current water level
same as PS-Light-2 Sensor but additionally with:
— Data Logger
with RS232 interface
PS-Light - 2 Sensor LCDsame as PS-Light-2 Sensor but additionally with:
— LC-Display for digital indication
of current water level
PS-Light - 2 (-Logger) LCDsame as PS-Light-2 Sensor but
— Data Logger
with RS232 interface
additionally with:
— LC-Display for digital indication
of current water level
Optional:
Puck antennaDirectional Antenna (for mast mounting)bubble mouth piece (orifice)pressure tube**
**Pls specify length of tube when ordering!
SEBAConfigWinOperate DEMASdBWiski/Soda
SEBAConfigDEMASdBDEMASvisDEMASole
PC - Desktop Computer
represented by:
Technical Data
Fotos: © SEBA Hydrometrie GmbH, Pixelio.de
or via Notebook with SEBA Config or via HDA-Pro
Transfer of Measuring Data to PC
Online: analogue, via 0...5V resp. 0/4...20mA output signal
Offline: via HDA-Tablet
or via fixed network telephone communication digital, via GSM/GPRS network
The right is reserved to change or amend the foregoing technical specification without prior notice.
Power Supply
Readout & Configuration : SEBAConfig and DEMASole
- PS-Light powersupply, 220VAC/12VDC
- Solar power supply is possible
Software
- PS-Lightpowersupply, buffered with 7,2Ah - Battery 100Ah
Management /Evaluation Software: DEMASdB / DEMASvis
- PS-Light powersupply, buffered with 100Ah
Housing for measuring range: Weight:
PS-Light-2: plastic material (Ip65), 0-10 m 240(W) x 160(H) x 94(D) mm 1,6kg
0-40 m 250(W) x 410(H) x 100(D) mm 4,5kg
PS-Light-2 (for all types):
Sensor linearity: 0,05% of the measuring range Total Accuracy: Linearity + Hysteresis + Repeatability < 0,1%
Measuring Range: 0 - 10m, 0 - 20m, 0 - 40m, 0 - 70m
Analog resolution: 14Bit = 0,008%
0-20 m 240(W) x 160(H) x 124(D) mm 2,0kg
Outputs: 0-1V or 0-5V or 0/4...20mA, optional: Rs485 Modbus, SDI-12, BCD-, Binär-, Gray-Code
Digital resolution: 16Bit = 0,002%
Clock-, average- and eventmode are freely programmable
Interface: RS232, Rs485, USB, Bluetooth
Measurement storage: Ring storage, 16-bit resolution, storage of check values.
Supported networks: GSM/GPRS/EDGE/UMTS/HSDPA/HSDPA+
SIM-card: 1.8V / 3V
Flash-Memory: 16 MB for approx. 1.120.000 measuring values
SEBA - Data Logger (for types PS-Light-2 Logger and PS-Light-2 Logger LCD):
Microprocessor: 32Bit
Option: LC-Display for instant indication of water level
Operation Temperature: -20°C to +60°C
max. 32 channels (water level, battery voltage, external channels RS485)
Mobile Modem (for type PS-Light-2-3G+):
Antenna impedance: Dual band antenna TNC-connector 50 Ohm
Max. consumption: max. 400mA
Measuring Interval: freely programmable from 2 minutes via software SEBAConfig
Measuring Interval: freely programmable from 2 minutes via software SEBAConfig
Frequency: 850/900/1700/1900/2100 MHz (Worldwide)
Power Supply: 11...15 VDC
technical data for HDA and HDA-Pro pls see separate brochure HDA-Tablet
HDA-Prorobust tablet-PC
SEBAconfig
DEMASvis
Gewerbestr. 61a • 87600 Kaufbeuren • Germany
SEBA Hydrometrie GmbH & Co. KG
E-Mail: [email protected]
Phone: +49 (0)8341 / 9648-0
Internet: www.seba.de
Fax: +49 (0)8341 / 9648-48