Upload
kamal-kumar
View
6
Download
1
Embed Size (px)
Citation preview
OCEANEERINGINDUSTRIAL
RADIOGRAPHY SITE WORKS
CHECK LIST Job request and NDT procedure
Vehicle Pre-Start
Travel documents
Code and specifications
Equipment checked and calibrated
Calibration certificates ( if required )
Emergency kit
JSEA written and signed
TAKE 2 / step back 5X5
ONSITE RADIOGRAPHY Visually inspect the work area ( Look for doors / Opening
/Rooms into barricaded )
Do your JSEA before doing anything at site
Setting up barriers
Make a barrier plan
Keep monitoring the dose rate
Controlled area within 25μsv/hr.
Extend the barrier / use additional shielding if the controlled area is more than 25μsv/hr.
Take 2 once the barrier is controlled
Look for non radiation workers during the onsite radiography
Define the boundary using warning signs and notices
Warning lights and audible alarm to be located adjacent to exposure point
Ensure each source in use is properly separated and barricaded and different monitors allocated
ALARA: As low as reasonably achievable i.e., radiation dose should be as low as practicable
ONSITE RADIOGRAPHY
DUTIES OF A RADIOGRAPHER Its mandatory that Technicians are qualified and
certified for the tasks being performed
Ensure that right calibrated equipment is carried
Make sure all paper works are filled in a timely manner
Make sure to have a good relationship with clients
Ensure the job is done safely
Keep the work place clean and tidy before & after commencing work
Always wear appropriate PPE, PDE & TLD
Make sure the TLD’s are worn and current
SAFE DISTANCE BARRIER DISTANCE MUST NOT EXCEED 25usv/hr.
For IR192 the distance will be calculated using inverse square law
For x radiography the distance calculated during the x-ray set warm up
Use proper shielding to reduce the dose rate Incase of emergency please inform your
supervisor, HSE team
IF YOU ARE AN RPS Ensure that the radiographers are wearing
appropriate PPE
Ensure that TLD’s worn and current
Ensure that the site radiography is controlled
Ensure that the barriers dose rate is within the limit
Verify all paper works are properly done
Make sure to be present on site all times during radiography
Ensure all the works are completed safely
AFTER RADIOGRAPHY Make sure all equipment are disconnected
Make sure all equipment are in good condition
Make sure that you inform the clients that work completed
Tag out any faulty equipment
Make sure that you carry out all the travel docs and tools back to the workshop safely
Any hazard, near miss kindly inform your supervisor or HSE team
You are responsible for your safety
THANKS FOR YOUR VALUABLE TIME
AND IT’S
HOME TIME
DRIVE SAFELY