Upload
others
View
2
Download
0
Embed Size (px)
Citation preview
Page 1 of 3 ©2019 AccuQuilt PQ11598
GO! Woodland Fox Baby Bib Finished Size: 7-1/2" x 12"
Page 2 of 3 ©2019 AccuQuilt PQ11598
Dies Needed: GO! Baby Bib (55864) Additional Supplies Needed:
• ½” square of Hook and Loop tape per Baby Bib Fabric Requirements:
Fabric Color Total Yardage
Fox Fabric 3/8 yard Tone Dot Fabric 3/8 yard
Cutting Directions:
Fabric Color Die Number of Shapes to Cut
Fox Fabric GO! Baby Bib (55864)
Cut 1—13" x width of fabric (WOF) strips. Fanfold to 9" on die. Sub cut into 6 baby bibs—3 right facing and 3 left facing. (6 baby bibs for 60” wide fabric, or 4 baby bibs for 45” wide fabrics)
Tone Dot Fabric
GO! Baby Bib (55864)
Cut 1—13" x width of fabric (WOF) strips. Fanfold to 9" on die. Sub cut into 6 baby bibs—3 right facing and 3 left facing. (6 baby bibs for 60” wide fabric, or 4 baby bibs for 45” wide fabrics)
Page 3 of 3 ©2019 AccuQuilt PQ11598
Sewing Directions: Press all seams open and use ¼" seams, unless otherwise indicated. NOTE: Directions will be for one complete baby bib.
1. Place one left facing fox fabric bib and one right facing tone dot fabric bib right sides together and pin.
2. Stitch around perimeter of bibs with a ¼” seam allowance leaving 3” opening for turning.
3. Clip curves.
4. Turn right side out through 3” opening and press. A hemostat is helpful in this process.
5. Top stitch around perimeter of bib.
6. Hand stitch opening closed.
7. Apply Hook and Loop tape to strap and neck.