20
P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

  • View
    225

  • Download
    0

Embed Size (px)

Citation preview

Page 1: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

P.P., APD and PIN test report

Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang

2008/July/04

Page 2: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Motivation

We have two kind of samples aiming for the upgraded ECL (in super Belle). Photopentode (PP) x3 Avalanche photodiode (APD) x4

We hope to know the stability of their gain factors.

Page 3: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Make a black box for testing: picture1

60cm

40cm

40cmAluminum Framework: 40cm x 40cm x 60cm

Page 4: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Make a black box for testing: picture2

60cm

40cm

40cm

Page 5: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Samples

ZG2630ZG2632ZG2636

0705

0724

NO.7NO.8

PP x3 APD x4

Page 6: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Cool the air inside the black box

In Taipei, the weather in summer is very hot. We hope to reduce the testing temperature. (similar as in KEK.)

Cooling module: 15*15*3.3mm

Page 7: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Cooling Setup

FAN

HEAT SINK

HEAT SINK

FANCOOLING WIND for inside box

HEATING WINDfor outside box

COOLING MODULES

From Heating Wind: 34°C

From Cooling Wind: 15°C

Page 8: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Black box with cooling module: picture3

8

Page 9: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Black box with cooling module: picture4

Black Box

Monitoring program

heat insulation blanket

Page 10: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Black Box1: PP inside

P.P.

Temperature control

Polystyrene, coat with black lacquer

PIN

Page 11: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Circuits for PP

11

PIN CIRCUITS

Page 12: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Definition of Gain for P.P.

diodediode

pentrodepentrodePP VdarkVVlightV

VdarkVVlightVGain

)100()100(

)1000()1000(

Page 13: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Results of P.P. (3 piece)

We can’t repeat our previous measurement results. Problem is

After checking our circuits with Kuzmin-san, we found our diode-mode circuit was wrong. Now, we know how to fix it.

0)100()100( diodediode VdarkVVlightV

Page 14: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Black Box2: APD inside

APD

PIN

Page 15: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Circuits for APD

PIN CIRCUITS

APD High Bias Voltage

APD Low Bias Voltage

Page 16: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Definition of Gain for APD

)10()10(

)300()300(

VdarkVVlightV

VdarkVVlightVGainAPD

Page 17: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Results of APD (4 piece)

APDNO7 Average = 30.07

APD0705 Average = 4.67

APD0724 Average = 4.90

APDNO8 Average = 3.14

Page 18: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Results of APD (4 piece)

It takes 20 minutes to finish the data taking.

The data record period is 1s.The temperature precision is 0.1℃.

Page 19: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

PIN & APD output voltage

Page 20: P.P., APD and PIN test report Eric Chiu & Ken Chiang & Alex Chang & Jeri, Ming-Chuan Chang 2008/July/04

Summary

APD measurement is more or less normal.

We met problems for PP measurement. But we know how to fix it now.