Upload
buingoc
View
220
Download
0
Embed Size (px)
Citation preview
PowerBeats2 Wireless Headphones by Dr. DreBattery Replacement
Replace the battery on PowerBeats2 Wireless Headphones by Dr. Dre
Written By: Faizan Naveed
PowerBeats2 Wireless Headphones by Dr. Dre Battery Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5
TOOLS:Heat Gun (1)
Pry Bar (1)
Soldering Station (1)
Super Glue (1)
Binder Clip (1)
PARTS:PowerBeats2 Wireless by Dr. Dre
Replacement Battery (1)
PowerBeats2 Wireless Headphones by Dr. Dre Battery Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5
Step 1 — Locate Battery.
The battery is located inside theright side ear piece.
Step 2 — Heat Right Side.
Heat the right side gently at 140 Ffor about 3 minutes.
Do not over heat or it will melt thehousing.
PowerBeats2 Wireless Headphones by Dr. Dre Battery Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5
Step 3 — Remove Battery Cover/Casing
After heating, gently remove the cover/casing as shown in the picture.
Take your time and re-heat if cover/casing does not remove smoothly.
Step 4 — Desolder & Replace Battery
Desolder battery using soldering ironand replace with replacementbattery.
PowerBeats2 Wireless Headphones by Dr. Dre Battery Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2017-08-05 02:04:10 AM.
Step 5 — Reattach Battery Cover/Casing
After battery is replaced, apply super glue to the border of the inside of the battery cover/casingand put it back in place.
Use small clamps/binder clip to hold the housing in place while the super glue dries up.
PowerBeats2 Wireless Headphones by Dr. Dre Battery Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5