How to Flush Your Water Filter

If you have questions, don’t hesitate to call us.

We’re always available to help. Call us any time at

630-584-8888.

STEP ONE: Grab a large container that fits in the water dispenser of the refrigerator (this can be a large measuring cup, a large drinking cup, or anything big enough that conveniently and comfortably fits into the dispenser).

STEP ONE: Position the container in the water dispenser and press to begin dispensing water. Fill the container as much as possible.

If you have a fridge that dispenses water and ice cubes, you know that you need to replace your water filter from time to time. When you replace that filter, have you ever thought about flushing your system? Flushing your water filtration system can remove various carbon deposits that will lend a bad taste to your water (and that will clog your new filter).

Manufacturing and shipping can cause the carbon particles in a new filter to knock loose. This often causes the first few glasses of water to contain bits of carbon, making your water cloudy. While the carbon bits will not harm you, most will not want to drink it as it can leave a bitter taste.

Keeping the system flushed keeps your filter working effectively, your water tasting clean, and your system efficiently maintained.

The number of times you will need to fill the container depends on the type of container you are using. For example, if you are using a 4-cup measuring cup, you will need to fill it four times to make one gallon. Remember: four cups equal one quart and four quarts equals one gallon.

STEP THREE: Discard the water into the sink.

STEP THREE: Repeat steps 1-3 until you have flushed 3-5 gallons of water.

2015 REFRIGERATOR

MAINTENANCE

For specific directions to flush your refrigerator water filter, check the owner’s manual. Instructions can vary slightly depending on the type of filter you have so the owner’s manual will be the safest way to ensure all installation and setup processes are followed correctly.

PlumbingBlogTwo.pdf